What do you need to know about the Aqua Trol?
What do you need to know about the Aqua Trol?
The Aqua Trol®is an automatic chlorine generation system for above ground pools. The operation requires a low concentration of salt (sodium chloride) in the pool water at levels low enough that it normally will not be tasted.
How to reset Aqua Trol diagnostics Manual Step by step?
Requires manual reset. To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds). Step A
How to prevent electrocution from Aqua Trol diagnostics?
Aqua Trol Diagnostics Hazardous voltage can shock, burn, cause serious injury and or death. To reduce the risk of electrocution and or electric shock hazards: • Only qualified technicians should remove the panel • Replace damaged wiring immediately • Insure panel is properly grounded and bonded
Is the Aqua Trol an above ground chlorine generator?
The Aqua Trol Electronic Chlorine Generator (likewise called a sodium chlorinator) is actually created exclusively for Above-Ground swimming pools around 18,000-Gallon. The Aqua Trol possesses just the same features as well as components of the Aqua Rite however along with a lesser bleach outcome.
The Aqua Trol®is an automatic chlorine generation system for above ground pools. The operation requires a low concentration of salt (sodium chloride) in the pool water at levels low enough that it normally will not be tasted.
How to reset the inspect cell led Aqua Trol?
To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds). Step A If salt level is within range, go to step B. If salt level is below range, add enough salt to achieve a salt level of 3200ppm. (Refer to Salt Chart, Page 27) Step BInspect and/or Clean Cell
How big does an aqua Trol pool pump need to be?
The Aqua Trol incorporates a built in timer to control the pool pump, controls a T-cell-5, and is designed to handle the sanitization needs of above ground pools up to 18,000 gallons. The actual
What should DC voltage be on Aqua Trol?
Remove and/or reseat DSP board. Pins may be shorted together or not making contact with connector. If pins are good, check for 3 to 5 volts (DC) on pins 2 & 4, starting from the left. If DC voltage is correct, replace DSP board.