What does a Williams valve do?

Established in 1918, Williams Valve Corporation manufactures quality valves including check valves, ball check valves, cast steel swing check valves, and stainless check valves for industrial and commercial applications worldwide.

How do I know if my air regulator is bad?

The most common signs of bad or faulty pressure regulators include:

Leakage between the device’s housings.
Misting or overwatering in some areas.
Increased water and energy consumption.
High-pitched squealing.

How does an adjustable pressure regulator work?

The adjustment screw pushes down on a spring which applies a force onto the valve. When the pressure inside the bottom chamber of the FPR exerts a high enough force on the valve. This allows fuel to flow through the outlet port effectively controlling the fuel pressure in the fuel rail.

How does a pressure protection valve work?

The inlet (supply side) of a protection valve is normally closed and does not open until pressure at the supply side, usually in a reservoir, reaches an opening threshold. When the pressure on the supply side falls the valve closes to preserve some amount of air pressure on the delivery side of the valve.

Where are Warren valves manufactured?

Houston, Texas
Established in 2019. In 2019, Warren Valve opened a state-of-the-art trunnion ball manufacturing facility in Houston, Texas.

How do you test a regulator on an air compressor?

Depress the spring valve several times. Wrap plumber’s tap around the air regulator screw fitting and screw it back into the tank flange with the wrench. Turn the compressor on and fill up the tank to the operator’s specified pounds-per-square inch. Check the reading on the air regulator gauge and the tank gauge.

Is 70 psi water pressure too high?

Normal psi for a home pipe system is between 30 and 80 psi. While you don’t want the psi to be too low, it violates code to be above 80. Instead, you should aim for a psi that’s between 60 and 70.

Is 55 psi water pressure good?

The water pressure in a plumbing system should be between 45 and 55 psi (pounds per square inch). If the pressure rises above 60 psi, it can create problems for the plumbing, including damage to the pipes. In most cases of high water pressure, a professional must analyze the problem and find a solution.

How is the poppet of a pressure regulator opened?

In the pictured single-stage regulator, a force balance is used on the diaphragm to control a poppet valve in order to regulate pressure. With no inlet pressure, the spring above the diaphragm pushes it down on the poppet valve, holding it open.

Who is Williams controls?

Williams Controls Inc. was established in 1937 as a manufacturer of vacuum water valves used to keep the brake drums of logging trucks and trailers in proper operating temperature. It was founded in Portland, Oregon, by Norman C. Williams.

Where can Williams’ electronic throttle controls be installed?

Williams’ electronic throttle controls can be installed in buses, motor coaches, medium- and heavy-duty trucks, agricultural vehicles, construction equipment, material handling equipment, and other specialty vehicles. These ETCs are offered in three unique designs:

How does a wm279 pressure regulator work?

Application: The WM279 series valves are self-relieving pressure regulators that are available with either hex screw (WM279E1) or knob (WM279R2) for output adjustment. The operator regulates the output level by manually changing the position of the knob or screw. Both models maintain a constant output within the regulator’s pressure range.

What is an activeair valve controller?

The Williams Controls Activeair controllers are precision regulating valves that are designed as up to 5-unit banks. The Activeair System, with this controller and their actuator, is made for certain hydraulic valves. We also have their joystick controller and regulating controller.