What does E5 mean on a hot tub?
What does E5 mean on a hot tub?
High water temperature indicator
E5 – PROBLEM: High water temperature indicator, All functions do not work, beeping warning, The filled water is over 50°C(122°F) – SOLUTIONS: Unplug the Control unit and contact your dealer for service.
What does the E6 code on a hot tub mean?
The E6 code is a warning that there is not sufficient water flow for the power pack to continue operating without possible damage. The power pack must shut down for self preservation.
What do the error codes on a hot tub mean?
Error codes indicate a problem and give you a good idea of what is wrong as long as you know what to look for – below are the error codes, but we have provided a brief guide to what the common faults are and the remedies. OH = Overheat Protection (Heater is deactivated, pumps low speed is activated).
What does E1 mean on an engine block?
Your engine block shows the error code E1, E3, E4, E5, E6 ou E8. These error codes indicate poor water flow in the filter pump. Check that the water line in the pool is between the min and max limits. If this is not the case, fill or empty your spa so that the water line is between these two limits.
What does ECN stand for in hot tub?
Ecn or Ec is ON Solid (Not Flashing): The Current Water Temperature is “Unknown” (- – – or – -) while in Economy or Sleep Mode. Between Filter Cycles, while in the Economy or Sleep Heating Modes, the Pump has not turned ON and the Last Water Temperature is not current.
The E6 code is a warning that there is not sufficient water flow for the power pack to continue operating without possible damage. The power pack must shut down for self preservation.
Error codes indicate a problem and give you a good idea of what is wrong as long as you know what to look for – below are the error codes, but we have provided a brief guide to what the common faults are and the remedies. OH = Overheat Protection (Heater is deactivated, pumps low speed is activated).
What does seop stand for in hot tub?
SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional. Heater disabled but the spa is operational. PSoC = Pressure switch open with circulating pump. PSoL = Pressure switch open with low pump.
What does it mean when your hot tub says PF?
Indicates a hot tub power failure. The power is fluctuating in the 2ndary power line resulting in low DC voltage. Attempt to rest the spa power, The PF error will reset itself if power levels return to normal. Contact the dealer or service technician if the problem continues.