What does E6 mean on a lazy spa?

What does E6 mean on a lazy spa?

The E6 error code on your hot tub usually refers to a reduction or stoppage of water pressure. The E6 code is a warning that there is not sufficient water flow for the power pack to continue operating without possible damage. The power pack must shut down for self preservation.

How do I check the exhaust temperature on my Mastertemp?

When the heater is running hold the “pool” or the “spa” button for 12 seconds. This will show the exhaust temp, if the temp is rising above 375 degrees with in 1-2 mins then your not getting the heat out of the heat exchanger. One other thing to check would be an external by-pass.

How do I fix my E6 in my hot tub?

Purge air from the PCU to remove an air lock by following these steps:

1. Turn OFF or unplug the unit.
2. Unscrew the air purge valve (flower-shaped knob) counter-clockwise.
3. Bleed filter housing until water escapes and no more air, tighten back up.
4. Turn on Filter mode and check for circulation at discharge port in tub.

What is error code E6 at the air conditioner?

An E6 error code is a communication error that the inside unit is not able to communicate with the outside unit. This includes the high voltage and low voltage lines.

What’s the normal code on a Pentair mastertemp 400?

The 126 is the normal code displayed at boot up of the heater. What temp is the ET set to? What temp does the ET say the water is? Is the heater also cranked all the way up to 104 on the spa setting?

Is the mastertemp pool heater the same as the Max-E therm?

The controls and circuit boards for the Max-E-Therm and the MasterTemp are fairly identical. Even the new MasterTemp aboveground pool heater has the same design, and the same troubleshooting procedure. The error codes below can get you started with understanding what your heater is trying to tell you.

When did the Pentair mastertemp pool heater come out?

Pentair pool heaters come from the legacy of the Purex-Triton Minimax heater, when Pentair purchased the Purex company. In 2004, Pentair acquired the Sta-Rite company and it’s Max-E-Therm heater technology. The Pentair MasterTemp pool heater adopted the sealed combustion chamber with controlled exhaust design.

The 126 is the normal code displayed at boot up of the heater. What temp is the ET set to? What temp does the ET say the water is? Is the heater also cranked all the way up to 104 on the spa setting?

The controls and circuit boards for the Max-E-Therm and the MasterTemp are fairly identical. Even the new MasterTemp aboveground pool heater has the same design, and the same troubleshooting procedure. The error codes below can get you started with understanding what your heater is trying to tell you.

Pentair pool heaters come from the legacy of the Purex-Triton Minimax heater, when Pentair purchased the Purex company. In 2004, Pentair acquired the Sta-Rite company and it’s Max-E-Therm heater technology. The Pentair MasterTemp pool heater adopted the sealed combustion chamber with controlled exhaust design.