What does F1 mean on my hot tub?

On page 29 it shows that “F1” indicates the spa is running the factory default 1 hour filtration cycle. It indicates this should run one 30-minute cycle every 12 hours.

How do you reset the code on a 616 Jacuzzi?

Reset “616” Code on 2012-2013 J-300 & LX Collection Models:

Press and hold the Jets pump 1 and Cooler (-) button at the same time for 3 seconds.
Press the Warmer (+) button until the display shows “0”.
If the timer has reached “0”, pressing the Jets pump 1 button will reset the counter.

What does 616 mean on jacuzzi?

The “616” error code is displayed when your 365 day ClearRay Bulb timer has reached zero. TO reset your ClearRay timer, please refer to our “616” reset instructions here.

How do you reset the code on a hot tub?

Solution A: Increase the hot tub water level Switch off the power and remove the filters. After 20 minutes, switch the power back on and run the spa/jets without the filters to see if it clears the flow issue. If the flow clears, switch off the power again, replace the filter and then switch on the power.

What to do if your jacuzzi is flashing FL-1 code?

If you have a Jacuzzi and the topside is flashing FL-1 code and the heat is not working ? This is your DIY ( How Fix My Spa VIDEO ) In this video I will show you STEP BY STEP what to look for and check to figure out what is the problem and why the heat is not working along with TIPS on how to get your Jacuzzi heating and running again…

How to fix jacuzzi brand hot tub error messages?

Press either + or -. This will change the display to = and will disable the countdown timer that creates the original message. Contact your dealer for replacement. Next up are the hot tub error messages for the newer Jacuzzi® series, J-400 and J-500 series. They have a full digital display, which will indicate what is wrong.

What is the error code on my jacuzzi heater?

If you power the spa back on and these steps don’t correct the error code, it is time to start troubleshooting the circuit board, sensors, and possibly the heater or topside (though not likely). Q:My control panel reads the error code “SN1.”

What does FL1 mean on a hot tub control panel?

Q: My control panel is flashing the error code “FL1.” What does that mean? A: This is absolutely the most common error code for a service call. However, most of the time, there really is nothing wrong with the spa. Turn your breaker off. Remove your filters.

How to fix no heat on Jacuzzi in Arizona?

Flashing FL-1 code and no HEAT on Jacuzzi (DIY) Step by Step how to FIX. Arizona Hot Tub Factory Flashing FL-1 code and no HEAT on Jacuzzi (DIY) Step by Step how to FIX. Arizona Hot Tub Factory Flashing FL-1 code and no HEAT on Jacuzzi (DIY) Step by Step how to FIX.

What does it mean when your jacuzzi water is too hot?

After the pump primes itself, the error message should go away.5. Contact dealer or a service technician if problem continues. One of the sensors detected that the water in the hot tub is 112°F (44°C). Stands for “Overheat”- and the tub shuts down because water temp is too hot.