What does FL2 mean on a hot tub?
What does FL2 mean on a hot tub?
FL1/FL2. This code means any of the following: the flow switch is malfunctioning open (FL1) or closed (FL2), the filter cartridge needs to be changed or cleaned, or there is an “air lock” condition at the circulation pump intake.
What does FL2 mean?
FL2
| Acronym | Definition |
|---|---|
| FL2 | Facelift Two |
How do I fix error code e02 on a lazy spa?
Please follow these steps to resolve this:
- Remove the spa pump from the liner, with the stopper caps placed on the inside.
- Empty the spa fully of water.
- Remove the stopper caps and place a hose on the inside of the spa, up against the debris screen.
- Complete this for 5 minutes on each debris screen.
What is an FL2?
The doctor will complete a FL-2, this is North Carolina’s form that describes a patient’s medical condition and the amount of care they need when placed in a facility. A completed FL-2 form is required for Medicaid recipients admitted into any long term care facility.
What is FL2 dental?
FL2 mean that “Fluoride” for Dental.
What does the code E02 mean on a lazy spa?
E02 ERROR CODE REASON WATER LEVEL IS NOT CORRECT. The water flow sensors will not detect the water properly if the water is below the minimum line. on the spa liner.
Why is the filter light red on lazy spa?
The pump will heat the spa water until the water temperature reaches 1°C (1.8°F) higher than the set temperature. The light above the Water Filter Button displays red when activated.
Why do I get a FL2 code on my hot tub?
The final reason you may get an FL2 code is because the circuit board may be misinterpreting the information it is receiving from the flow switch or pressure switch. While this is very rare, it would mean a circuit board replacement is necessary. That said, this is an easy error code to troubleshoot. Does that pump turn on and off like it should?
What’s the difference between FL1 and FL2 error codes?
An FL2 error code and FL1 error code are often confused for one another. While an FL1 error code means the spa isn’t sensing enough water flow to close the flow switch, the FL2 error code means exactly the opposite.
What causes a FL1 code on a pump?
An FL1 code can be caused by several things: Soiled filter, air lock, kinked circulation pump line, blocked circulation pump line, plugged circulation pump, bad circulation pump, plugged Flow switch, poor connection from PWA to Flow switch, bad Flow switch.
Why does my hot tub have an error code?
Some of the most common hot tub error codes are FLO, FL1 or FL2, and are picked up by flow or pressure switches. The most common causes for this are a dirty or damaged filter, low water levels, air in the pipework or a faulty pump or sensor..