What does it mean if my resort spa has 3 lights flashing on the panel?
What does it mean if my resort spa has 3 lights flashing on the panel?
“FLO”, “FL” and 3 blinking dots mean the same thing – the water flow through the heater is inadequate or the pressure switch is mis-calibrated and/or possibly defective.
How to troubleshoot an electrical problem in caldera spa?
Troubleshooting Caldera Spa Electrical Step 1. Look at the spa’s LCD screen. When the screen reads “Pd”, the power has been cut off. If it is blank and the… Step 2. Listen to the motor and the pump. A noisy motor or pump can be caused by closed-knife valves or low water level… Step 3. Add water …
Why are the red and green lights blinking on my spa?
If both red and green lights are blinking, this could indicate low water flow. Resetting the spa by turning off the power, waiting and turning it back on is likely to resolve the issue. If these troubleshooting tips don’t solve your problem, consult the owner’s manual for your controller. You can also contact the manufacturer for technical help.
How to troubleshoot an electrical problem in a spa?
Troubleshooting an electrical problem in a spa is something that anyone can do. When a spa does not work correctly, the owner must do a little detective work to figure out what the cause of the malfunction is. Most often, the problem is easily fixed and can be rectified in a matter of minutes. Look at the spa’s LCD screen.
What are the lights on a hot spring spa?
Hot Spring Spas communicate errors in tub function through two different lights. One is the Power light and one is the Ready light. On tubs before 2009 the Power light is red and the Ready light is green.
Why does my spa light keep blinking on?
Most of the time this is caused by a dirty filter, but it may mean the circulation pump has failed. An easy test is to remove the filters and turn on the spa, if the power light stays on it is time for new filters! If the power light continues to blink with out filters it is time for a service call.
Hot Spring Spas communicate errors in tub function through two different lights. One is the Power light and one is the Ready light. On tubs before 2009 the Power light is red and the Ready light is green.
What does the diagnostic logo light on caldera Utopia mean?
On Caldera Utopia® Series spas, the logo light serves as a helpful and visible diagnostic tool. When the diagnostic logo light shines orange and gray, the spa water is within 2° Fahrenheit of the set temperature and ready to enjoy. When the spa senses an issue, the diagnostic logo light may turn off, blink, or the colors may flash independently.
Why does my hot tub have a flashing orange light?
A flashing orange light indicates a problem with the temperature sensor. No orange light means that water temperature is outside of 2° F of the set temperature. A flashing gray light indicates that the heater high-limit thermostat has tripped, meaning that the spa water is above an acceptable temperature range or that there is a flow issue.