What does it mean when it says water SW open?
What does it mean when it says water SW open?
Since you stated that you’re not getting a good return to the pool, your most likely getting insufficient water flow through the heat exchanger, and this is why you are getting “water sw open” fault code.
How does the fault code work on a Raypak pool heater?
The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater. The models with digital thermostats are programmed to display a variety of status and diagnostic messages, depending on the operating conditions. They are also equipped with onboard diagnostic controls.
How to check high limit fault in Raypak?
I would start by removing the Hi Limit 2 from the header (should be yellow wires) and let it hang by the wires, and see if you still get the fault. If you do, remove the other high limit (black wires) and plug it into the yellow wires, and the other hi limit into the black wires (switching them). Let them both hang and check.
Are there any limits on the Raypak Hi Governor?
Raypak Hi Limits are, for the most part are fairly robust, and don’t fail that often. If you want to replace the unitherm governor, get part 006719F. Yes as Pool Clown said, the limits on the Raypak’s are pretty robust. Thanks guys, I appreciate the thoughtful insight. Pool Clown – Heater is outside.
What does BD1 mean on a Raypak heater?
The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings. Although an error message is never really a good thing, at least it’s an indication of what the problem is. Just imagine how much easier it would be to diagnose diseases if humans came with error codes.)
The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater. The models with digital thermostats are programmed to display a variety of status and diagnostic messages, depending on the operating conditions. They are also equipped with onboard diagnostic controls.
How to replace the front door on a Raypak heater?
Turn off the power to the heater. 2. Turn off the gas to the heater. 3. Remove front door by removing the large door screw shown in Fig. 3. 4. Remove the four screws on the side of the control panel. See Fig. 5and Fig. 6. 5. Lay control panel forward toward you to access the back of the temperature control board. r r REMOVE THESE SCREWS
The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings. Although an error message is never really a good thing, at least it’s an indication of what the problem is. Just imagine how much easier it would be to diagnose diseases if humans came with error codes.)