What does it mean when status light is blinking on water heater?
What does it mean when status light is blinking on water heater?
If the Status Light is flashing once every three seconds, the pilot light is lit and the gas control valve is working properly. Make sure the gas control valve is turned to “Hot” and wait for the water heater to heat back up. It may take several hours for the water to heat up.
How to turn on the blinking light on your water heater?
The basic method is: 1 Turn the knob to “Pilot Light” 2 Push in the knob and hold it in 3 Push the “Pilot Light” button next to the knob 4 Release the Knob
What to do if your electric water heater is not hot?
No Hot Water All electric water heaters and gas heaters that use electricity: The first issue to troubleshoot is a lack of power to the unit. If the water from the hot tap goes cold, give a gas unit 15 minutes and an pressure relief valve 30 minutes to start making enough hot water for you to notice at the tap.
What’s the blue light on my Honeywell water heater?
Honeywell water heater blinking blue light honeywell gas valve on a water heater clear 4 blink fault code on honeywell honeywell water heater blinking blue light Clear 4 Blink Fault Code On Honeywell Water Heater Gas Valve High Temperature Shutdown Try First You Bear Plumbing 20 Photos 615 Reviews Sun Valley North Hollywood Ca Phone Number Yelp
What to do when your status light does not blink?
If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.
The basic method is: 1 Turn the knob to “Pilot Light” 2 Push in the knob and hold it in 3 Push the “Pilot Light” button next to the knob 4 Release the Knob
Why is my electric water heater not working?
The most obvious reason an electric heater doesn’t work is that it’s not receiving any power. Start by checking the circuit breaker to see if it has been tripped. If it has, it’s an easy fix – simply turn it off and turn it back on again. You may also have to replace the fuse if it has blown. The next step is to check the high-temperature cut-off.
If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.
What does it mean when your water heater flashes?
Start with the small print on the control panel. Usually, the most common messages are printed right on the control panel. If it’s not on there, check the manual or look up your model number online. For some models, a single flash is normal: It means everything is fine. Elsewhere, there isn’t much you can do about an electrical issue.