What does it mean when your washer stops draining?

There are a few possibilities why your washing machine won’t drain. Your washer may have a clogged drain hose or the pump may be broken. A broken lid switch or belt could also be the culprit. It may even be something as simple as the hose being jammed.

Why would a washing machine suddenly stop working?

The number one reason why your washer suddenly stops working is that it has no power. The other option for sudden power loss to your washer is a flipped breaker. A breaker flips when one circuit is overloaded either with supply or demand. For example, running two appliances off the same circuit can flip a breaker.

What causes a Whirlpool dishwasher to stop draining?

If you’ve cleaned your filter and the dishwasher is still not draining properly, there may be another reason it’s clogged. Check your drain valve. If it’s stuck in place, that means the valve’s electrical components are probably burned out and it needs to be replaced.

Why does my Whirlpool washer start then stop?

The Whirlpool washer typically pauses momentarily right before the wash cycle begins, but if the wash cycle is interrupted with a delayed pause, the appliance’s water inlet hose may be clogged. Cleaning the inlet hose’s screen is necessary to remove hard water residue and restore the washer’s performance.

Why is my Whirlpool washer not draining properly?

It’s also a great idea to check that the drain hose is positioned correctly. If the hose is too far or not far enough down inside the standpipe, it can cause improper draining. This in turn causes the Whirlpool washer to not drain the water completely.

What to do if your Whirlpool washer is not spinning?

If your machine doesn’t do this, the washer timer is faulty and needs to be replaced. You can check this by monitoring the machine while the load is draining. Once it’s been draining for 3 minutes go ahead and open the lid and close it again. If it spins, replace the timer.

Where is the drain filter on a whirlpool washer?

You can find the drain filter behind the access panel on the bottom front of your machine. The filter is easy to clean and once it’s clean the water should flow better when draining from the machine. If the hose and filter are both okay, you’ll need to check the drain pump.

How does a whirlpool washer work when the water level is correct?

Electrical power is routed from the timer through the water level switch to the water inlet valve. When the correct water level is reached in the tub, the water level switch will remove power from the water inlet valve and direct it to the motor.

Why is my Whirlpool washing machine not draining?

Whirlpool washing machines have many features, such as automatic water levels, soil sensors, steam and sanitize clean and specific item cycles. However, if the washing machine does not drain completely, these features will not be of much use.

How to troubleshoot a Whirlpool dishwasher drain hose?

The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) – High level of foam inside. Repeat without detergent or wait until foam disappears. • Dirty filters. Clean the filters. – Kinked drain hose. The drain hose must not be kinked. – Syphon hose connection closed.

What should I do if my drain pump won’t run?

The motor drives an impeller to force water out of the drain hose. If the motor runs during the drain cycle, check for a blockage in the drain line. If the motor won’t run during the drain cycle or if… it just hums when it should be running, the pump and motor assembly might need to be replaced.

Why is my KitchenAid dishwasher not draining properly?

Drain pumps are not repairable—if the drain pump is defective, you must replace it. The drain solenoid opens the drain valve to allow the water to exit the dishwasher. If the drain solenoid fails the valve will not open causing the dishwasher not to drain.