What does N mean on a Norcold refrigerator?

n/no co Fault Code – No cooling detected by the controls Power Board Reset Procedure. Page 1. www.norcold.com/cda.

How do I reset my Norcold fridge board?

Press and hold the TEMP SET button on the fridge control panel. When ‘Er’ shows on the screen release the TEMP SET button. When ‘CL’ shows on the screen, wait five seconds and press and hold the TEMP SET button until ‘Er’ is shown on the screen again. Cycle the fridge off/on to see if the “no co” error is erased.

How do you reset a norcold 1200 refrigerator?

Open the refrigerator door and locate the control panel between the freezer and fresh food compartments in the refrigerator. Press and hold the “On/Off” button for a few seconds and then release. Wait several minutes and then press the “On/Off” button to restore power. This will reset the refrigerator.

What does N mean on RV refrigerator?

The “n” code can mean a number of things, including inadequate circulation of air to the fins and thermister that hangs off the fins. ( This may have been our problem, as the top shelf was packed full.) Other causes are listed in the manual.

What is lo DC Norcold refrigerator?

“DC lo” indicates the control board is receiving less than 10.5 volts.

Where is the fuse on a Norcold refrigerator?

You need to check the fuse, which is located in-line with the DC connector, and the polarity of the DC power supply. If the refrigerator still does not operate, another problem can exist in the inverter. Have an authorized Norcold Service Center check the refrigerator.

Can you reset a circuit board?

Turn off lights and unplug in any appliances associated with the circuit breaker. Locate your circuit breaker panel and open the metal door that covers the panel. To reset the breaker, put some pressure into moving the switch first into OFF, wait a few seconds, and then flip it back into ON.