What does PS mean on Hayward pool heater?

Adequate water flow through the heat pump causes the Water Pressure Switch contacts to close. Insufficient water pressure will allow these contacts to open, and turn the heat pump off. The display will read “PS” if the water pressure is not sufficient. Time Delay.

Why is my Bestway pool heater not working?

This error code is visible if there is an issue with the fuse within the pool heater. Please do not attempt to open up the pool heater, change the fuse or aim to resolve the issue. Please contact Bestway Swimming Pools regarding this due the issue.

Why does my pool heater not heat correctly?

POOL HEATER DOES NOT HEAT CORRECTLY REASON HEATING TIME IS TOO LONG SOLUTIONSCheck the LED light on the pool heater is working. Always use a pool cover REASON FILTER PUMP OR SAND PUMP DOES NOT MATCH THE HEATER SOLUTIONSReplace the filter pump/ Sand filter following the manual. REASON POOL HEATER SET-UP FAILED

How can I Reset my Bestway pool heater?

This error code is visible once the pool heater is required for reset. Push the reset button on the pool heater. Please find a photo below for the reset button on the pool heater. If the alarm is still visible, check the RESET BUTTON section on the manual below. If this does not resolve the issue, please contact Bestway Swimming Pools.

Why is the sand in my pool filter not working?

Your pool filter sand may look good, but it’s not doing its job at filtering out debris from the pool water. First, check your pool water chemistry with a good water testing kit to be sure the water is balanced correctly.

Can a too big sand filter cause bad filtration?

Too big or too small pool filter will cause bad filtration and the sand filter may clog up. Most manufacturers recommend No. 20 grade silica pool filter media . Check with your owner’s manual for the correct size of pool filter sand.