What does SLP mean on a hot tub?
What does SLP mean on a hot tub?
Sleep Heating Mode
If the SLP or SL Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Sleep Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles. The Water Temperature will probably drop Below Set Temperature between Filter Cycles.
What mode should hot tub be on?
The temperature of the hot tub will be reach & maintained when in standard mode. The hot tub will only use the heater when the spa is in “filter mode” and the water has encountered a drop in temperature below the standard thermostat setting.
What does F8 mean on a hot tub?
Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours). Preset cycle set from factory is F1, so if in ec or sl mode your water will not reach desired temperature.
Why is my hot tub not getting hot?
If your spa heater won’t heat, remove and clean the filter(s) to rule out a pressure or flow rate problem in your hot tub heater. Low water level, a clogged pump impeller, closed valves, clogged pipes, or blocked spa drain covers can also cause flow issues.
How long does a hot tub take to heat?
If your hot tub is located inside, and the air temp is around 76 degrees, it will take about 4 hours to heat up your spa to 100 degrees. The lower the outside temps the longer you will have to wait before your spa is ready. Therefore, by leaving the cover on while it’s heating up you can help it warm up faster.
Why are some of my hot tub jets not working?
Jets Are Not Working Properly When jets start failing, the most likely case is that your hot tub pump is not working correctly. Clogged filters or water intakes can also cause jet issues. Clean them to enhance water flow. If you cannot clean the filter properly, you may need to replace.
What does F2 mean on a hot tub?
The Big List of Spa and Hot Tub Error Codes
| CODE | ERROR CODE DESCRIPTION |
|---|---|
| F1, F2 | (Vita Spa) Blown fuse; replace fuse 1 or fuse 2 |
| F2 | 4 hours daily filtration; system message, not an error |
| F4 | 8 hours daily filtration; system message, not an error |
| F6 | 12 hours daily filtration; system message, not an error |
What do the 2015 South Seas and garden spa model numbers mean?
2015 South Seas and Garden Spa models may display, along with what they mean and the action required: Means that the temperature of the water is unknown. When the pump has been running for a total of 2 minutes, the temperature is displayed. Stands for “Overheat”- and the tub shuts down.
What is the pH level in a South Seas class spa?
You should maintain a slightly alkaline pH level, between 7.2 South Seas Class Spas carry a liftetime structure warranty. The struc- and 7.8, in the hydrotherapy spa.
What are the error codes for a spa or hot tub?
The Big List of Spa and Hot Tub Error Codes CODE ERROR CODE DESCRIPTION CP-ER Circulation pump error dr, dy, dry Dry – low water volume detected in heate E0 Short circuit temperature sensor E1 Open circuit temperature sensor
Where can I find the messages and alerts for the artesian spas?
Most messages and alerts for the Artesian Spas will appear at the bottom of the normally used screens. Several alerts and messages may be displayed in sequence. Some messages can be reset from the panel. Message that can be reset will appear with a “right arrow” at the end of the message.