What does the safety suction light mean on a Cal Spa?

The Cal Spa has a suction switch that will stop any dangerous suction if the spa thinks the pump suction is being blocked. There has been problem with these switches and they quit using them. This switch is usually located in front of the pump or may be by the heater and under a covering either yellow or blue normally.

What does safety suction mean?

A term used to describe a suction pumping system where the following are true: 1) There is only one check valve located immediately below the pump. 2) The pump is at a higher elevation than the tank.

How do you bypass the pressure switch on a hot tub?

“Jumping Out” the pressure switch refers to placing a jumper wire between the two spade terminals or brass screws on the pressure switch. By connecting a wire between the two “in” and “out” terminals, you essentially bypass the switch itself.

What does SF mean on hot tub?

SF stands for safety Suction Failure. It comes up when your hot tub doesn’t suck. Typically when something doesn’t suck, it’s a good thing. But here – it’s a problem! Water can’t be sucked into the water pump, typically due to blockages.

Can you bypass the flow switch on a hot tub?

Use another short piece of wire to connect the two wires you just pulled off that connect the spa to the main control panel. This action bypasses the flow switch and completes the electrical circuit back to the main control panel.

Do you need to measure for a Cal spa cover?

The Cover Guy custom manufacture’s all Cal Spas replacement Spa Covers. The Cover Guy has all the Cal Spa models on file so you never need to measure for your new hot tub cover! When ordering your Cal Spa replacement hot tub cover just leave the dimensions field blank.

What are the features of a Cal spa?

Cal Spas Swim Spas X-Series combines our best models from the Swim Pro™ line and takes it to the next level of visual and ergonomic design with new features such as Elite™ cabinets, Cal Grip™, Cal Touch4 Control™ and Cal Armor™. Hot Tub Hydrotherapy is essential for many of you in your daily routines and rehabilitation.

What to do if your Cal spas is out of sync?

Reset by depressing any button located on the top side panel. The temperature sensors are not in balance and are more than likely are out of sync by 2°F – 3°F. Put in a service call. Indicates that sensors that monitor temps are not in balance and ARE out of sync.

When did Cal spas start making hot tubs?

Cal Spas was founded in 1979, and they currently offer more than 250 product models. Each of their hot tubs can be customized from a list of thousands of options, and the company places an emphasis on innovative touches and quality workmanship.