What happens when the actuator on a door is down?

When the actuator moves the latch up, it connects the outside door handle to the opening mechanism. When the latch is down, the outside door handle is disconnected from the mechanism so that it cannot be opened. This makes the outside handle move without moving the latch, preventing the door from opening.

How to troubleshoot a Bal ACCU slide system?

BAL Accu-Slide™ System I. Troubleshooting 3 Service ManualPrin ted in the U.S.A. Solution: Call the service department to replace cable. See instructions included in the kit. (refer to section 2.02) Cause 5:Room stand-off bracket is loose or off Solution: Inspect all inside and outside brackets for secure attachment, and repair as required.

When to re-adjust an Accu slide system?

If an ACCU-Slide system is not making the proper seal when it is either open or closed, it needs to be re-adjusted. The best way to perform an adjustment is to open the room completely in order to have easier access to the cable adjustment brackets. With the room fully extended check top and bottom of both sides to verify all points have sealed.

How do you unlock a car door with an actuator?

There are a number of ways that you can unlock car doors that have door lock actuators, including: Using a key Pressing the unlock button inside the car Using the combination lock on the outside of the door Pulling up the knob on the inside of the door Using a keyless entry remote control Signaling from a control center

How to repair a door lock actuator step by step?

Part 4 of 6: Repairing the door lock actuator Step 1: Use a razor blade to open up the actuator.. Start on the corner by slicing your razor through the seam. Warning:… Step 2: Remove the electric motor from the actuator.. Pry up on the gear and pull it out. Then pry the motor up from its… Step

How do you turn off the slide out motor?

Press and hold the IN/OUT switch (Fig. 1B) in the OUT position until the room is fully extended and stops moving. 5. Release the switch, which will lock the room into position. NOTE: If the slideout switch is held after the room in fully extended, the control will sense that the room has stopped and will shut off the motor after a few seconds.

How does the Lippert electric slideout system work?

The Lippert Electric Slideout Systemis a rack & pinion guide system, utilizing an electric ball screw actuator to move the room assembly. The motor drives the ball screw in a forward and backward motion to drive the slide room in and out. The actuator comes equipped with an automatic clutching system.

How does the electric slide out system work?

1. Verify the battery is fully charged and hooked-up to the electrical system. 2. Press and hold the IN/OUT switch (Fig. 1C) in the IN position until the room is fully retracted and stops moving. 3. Release the switch, which will lock the room into position.