What is a spud washer on a toilet?
What is a spud washer on a toilet?
The spud washer fits inside the toilet on the base where the tank drains into the bowl. forming a seal here to hold the water in the tank. It is designed to be a water-tight solution for connecting the tank and seat portion together, while allowing a passageway from the tank to the bowl.
What is the purpose of the spud washer?
The spuds primary function is to create a seal. So, this seal holds the water in the tank. The place it fits on the base is where the tank drains into the bowl. It is supposed to be a water-tight solution for connecting the tank and seat portion together while also allowing passageway from the tank to the bowl.
Can a toilet tank be replaced with a spud washer?
While replacing toilet tank bolts, it is also a good practice to also replace the toilet tank to bowl gasket. This gasket is normally installed on the outside of the flush valve where the tank sits on the bowl. It is also called a spud washer.
What to do if you have a Spud in your toilet?
If your toilet does not have a spud, simply lift the toilet tank off the bowl after unscrewing the tank intake pipe. Lift the toilet tank off the bowl and empty the tank’s water in a sink or bathtub drain. Untwist the old spud and washer from the tank. Push the spud in with the palm of your hand to loosen it if necessary.
How does a spud wrench work in a toilet?
An internal spud wrench is used to hold the spud in place, while the nut on the outside is tightened to allow the washer to tighten evenly around the inside of the hole in the porcelain. The threaded side is for the connection from a flushometer to the toilet fixture or from the tank piping into the bowl (wall hung toilets),…
Do You need A spud to replace a washer?
Whether you need a spud, replacement washers, or even a specialty tool to remove and install them, we’ve got it. All are brass bodies and each spud comes with a rubber washer, friction ring, and brass locknut. Washer & friction ring available separately. An adjustable closet spud wrench is available below.
How to fix a spud washer on a toilet tank?
1 Remove the tank bolt with a screwdriver and adjustable wrench. 2 Clean the bolt and nut with white vinegar and a small wire brush. 3 If you aren’t replacing the spud washer, reinstall bolts and nuts with new gaskets. Alternate the tightening of the nuts to evenly draw the tank tight. 4 If you are replacing the spud washer, continue to Step 4.
An internal spud wrench is used to hold the spud in place, while the nut on the outside is tightened to allow the washer to tighten evenly around the inside of the hole in the porcelain. The threaded side is for the connection from a flushometer to the toilet fixture or from the tank piping into the bowl (wall hung toilets),…
Whether you need a spud, replacement washers, or even a specialty tool to remove and install them, we’ve got it. All are brass bodies and each spud comes with a rubber washer, friction ring, and brass locknut. Washer & friction ring available separately. An adjustable closet spud wrench is available below.
How does a closet Spud work in a toilet?
Closet (Toilet) Spuds. Please Note: The closet spud side (washer side) is the part that will fit into the hole in the porcelain fixture. An internal spud wrench is used to hold the spud in place, while the nut on the outside is tightened to allow the washer to tighten evenly around the inside of the hole in the porcelain.