What is the best material to level an above ground pool?

Crushed stone is a much easier material to use when leveling the ground than sand and it reduces the chances of critters burrowing under your pool. Stones used for leveling, often limestone, have to be crushed well. If you fail to crush the stones well, you should expect tears in your swimming pool in the future.

What to use for leveling an above ground pool?

What to Use for Leveling an Above Ground Pool. The most “off level” an above ground can get is around three to four inches off. This means when the pool is filled, on the one side the pool structure is three or four inches higher above the waterline than on the other side. Chief Obvious nature fact: Water is always level with the earth.

What should the level of a round pool be?

Most installers, despite their high level of knowledge and professional equipment they rarely get better than within an 8th of an inch level for a round pool and a ¼ of an inch on an oval pool. Most instruction manuals for above grounds are useless. If they mention leveling procedures, they usually say to level the pool to within an inch.

Can you have an above ground swimming pool?

Now think of an above ground swimming pool as a giant glass of water. Tilt the pool and the water stays level. I know this sounds obvious, but it’s not to some. Many things that are built can be “off level” and some wouldn’t notice but something that holds water can’t get away with being too “off level”.

What’s the best way to build a pool?

Place stakes or sticks at areas that slope or are off-grade. You’ll need to dig away these area in order to create level ground for the pool . Dig away soil instead of building up low patches.

How do you level an above ground pool?

The blocks are responsible for keeping the pool level. So, if you have an unbalanced pool, you have to hold up the blocks a little. With the use of the shovel, pry up the wall from the very bottom of the leveling blocks. Continue prying up until you achieve the preferred level. After achieving the preferred level, you can place the blocks back on.

How big is the arm of an above ground pool?

The arm is an 8′ length of 2″x4″ (as straight as possible) with a 2′ level taped to the top. For the center pin, we took a spare tent stake and ground one end down to a point. This will help it drive further into the wooden stake.

How do you level the blocks under a pool track?

Anyway, when leveling the blocks under the track, people do it in two ways. Most will lay down the pool’s bottom track, shape it and somehow mark where the connectors are and then take the track out of the way so they can level the blocks. Some will keep the track in place and level the blocks underneath.

Place stakes or sticks at areas that slope or are off-grade. You’ll need to dig away these area in order to create level ground for the pool . Dig away soil instead of building up low patches.