What is the drain lever called?

Also known as a foot plug, a push-pull drain stopper opens and closes just as its name describes. You pull up on its small knob to open the drain and push down to close it again. This simple drain stopper is easy to remove and install and has a long lifespan.

How do you use a bathtub lever?

There are also bathtub drain stoppers that can be operated with levers or knobs, including pop-up drain stoppers. A rod connects the lever or knob to a rocker arm that controls the stopper. Simply lower the lever or twist the knob to lower the stopper and lift or twist in the opposite direction to lift the stopper.

What is a trip lever for a bathtub?

The trip lever is the lever that makes the tub drain go up and down.

How does a trip lever bathtub drain stopper work?

First, it’s important to understand something about how this style of drain stopper works. The small up-and-down lever you see protruding from the overflow plate on your bathtub is connected to a vertical connecting rod inside the overflow pipe behind the front tub wall.

How do you remove drain lever from bathtub?

Wedge a 3/4-in. cold chisel into the cutout slot and pound counterclockwise with a hammer to free the stopper body (use caution when hammering so you don’t scratch the enameled tub). Completely unscrew and remove the stopper body.

Is there a Danco trip lever tub drain trim kit?

Repair your worn-out, non-functioning trip lever tub drain mechanism on the overflow faceplate and give your bathtub an updated look with the Danco bath tub drain trim kit. This complete bathtub drain conversion kit helps restore tub drains to like-new condition.

How to remove a bathtub drain stopper job?

All that’s left in this how to remove a bathtub drain stopper job is to install the new bathtub drain stopper body and stopper. Slide the new rubber gasket on top of the drainpipe under the tub and insert the new drain flange with plumber’s putty on it as shown here. Use the supplied bushing if the new threads are different from the old.

How to repair the trip lever in a tub drain?

How to Repair the Trip Lever in a Tub Drain 1. Unscrew the cover plate from the front of the bathtub, using a screwdriver. It’s usually held on by two… 2. Pull the lever out, then lift it straight upward to remove the linage from behind the tub. On the end will be a… 3. Excavate for the plug or

Where is the stopper on a bathtub drain?

You operate this drain stopper by using a trip lever that is installed on the overflow drain on the side of the tub, just below the faucet. This lever is attached to a rod that runs through the overflow drain and connects to and controls a stopper that is inside the drain, rather than on the tub’s floor.

How does a trip lever drain stopper work?

Usually, the problem is easy to fix, though the procedures vary depending on what type of tub stopper you have. Some drains have stoppers that are spring-loaded, operated by a push of the toe or by hand, while others use a trip-lever mounted on the bathtub’s overflow plate.

What’s the best way to lift a bathtub drain?

Check progress frequently to ensure you don’t cut into the tub. Wedge a 3/4-in. cold chisel into the cutout slot and pound counterclockwise with a hammer to free the stopper body (use caution when hammering so you don’t scratch the enameled tub).