What is the model number of the Sundance jacuzzi temp sensor?

Make sure this fits by entering your model number. EASY PARTS CHECK | This temperature sensor is Jacuzzi Part # 6600-167. It is also Sundance Spas Part # 6600-167. Check your service manual to ensure compatibility with your spa

Are there any error codes for a jacuzzi?

Hence the need for a BIG LIST of CODES. The alphabetical list of hot tub error codes below covers all major manufacturers of spa controls, including ACC, Balboa, Brett Aqualine, CTI, Dream Maker, EasyPak, Gecko, Hurricane, Jacuzzi, Len Gordon, Maax, Pinnacle, Spa Builders Group, Spa Quip, Sundance and Vita Spas.

When does the jacuzzi heater automatically turn on?

Condition that provides freeze protection and activates if temps raise to more than 20°F (6°C) cooler than set point of the temperature. Heater will automatically turn on when this happens and stay in this mode until water temperature reaches 15 degrees below set temperature. No action needed.

What does no action required mean on a jacuzzi?

No action required.Note: this condition often occurs when filling the spa with water since tap water is usually cold. This only occurs when spa is in Economy mode and stands for “Ice;” means the system has detected a potential condition for freezing and will cause the system to implement freeze protection. No action is needed.

Why is my j365 Jacuzzi hot tub leaking?

We found 2 main leak problems with our J365 Jacuzzi hot tub – one of the pump hoses had come off from the pump and was leaking. Easy enough to fix with a band clamp. The other issue was apparently one that had been going on for some time – the little ‘waterfall’ pump had been leaking. So, it was time to replace it.

What does an error code on a jacuzzi mean?

Error codes are your hot tubs way of telling you what’s wrong. This not a comprehensive list, but it’s a great start and covers almost all common problems. SN1Open Hi Limit Sensor. ould also be shorted. Replace Hi Limit Sensor. SN3Open Temperature Sensor. ould also be shorted. Replace Temperature Sensor.

When does the blow out function on a jacuzzi turn off?

An automatic five minute “blow-out” function also activates pump 2 for a period of five minutes to flush all lines. Then, after five minutes, pump 2 turns off and pump 1 continues to operate for the duration of the cycle. Note: This function only occurs during the first filtration/heating cycle each day.

How do you remove sensor from Sundance Spas?

To Remove a sensor or switch wire from the sensor harness connecto r (J6), Insert the end of a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine,allowing the wire to be pulled from the harness connector.

Can a bad temp sensor cause a spa to stop working?

Another issue that comes up and is an indication of a bad temp sensor is the temperature reading becomes inaccurate or the spa is going into the OH error code. If you power the spa down and power it back up it may work for a while but will do the same thing again. You need to replace the Temp Sensor.

What happens when Sundance spa goes into watchdog?

When the spa goes into the Watchdog the spa will not operate. This is how it happens: When you try to use the spa, you will see 3 or 4 dashes on the control panel (depends upon the model). If you try and reset your breaker, sometimes it comes on but it will probably go back into Watchdog error – – – -.