What kind of igniter does a Hayward pool heater use?

It’s a 1016-405 Series Direct Spark Igniter, but you need to pay attention to the part number on the white paper sticker, it is a 1016-458 variant.

What makes a Hayward Universal H series heater so good?

All H-Series heaters come with an LED control panel. This front panel makes it easy to use and convenient to monitor heat performance. The ignition system is very dependable and kicks in with one push of a button. What’s best about H-Series heaters is that the air is constantly moved through the combustion chamber due to a forced draft system.

Why was the Hayward H Series Pool chosen?

The Universal H-Series represents the winning combination of rugged design and efficient functionality which makes it an intelligent choice for modern swimming pools. Hayward’s heating systems follow an economical approach to energy consumption which means they are light years ahead in efficiency compared to gas heaters of even 5 years ago.

Is the Hayward pool heater 100V or 220V?

Dual Voltage – Hayward H-Series pool heaters are adaptable to both 100V and 220V. Universal Wiring– Installation is simplified due to high and low voltage connections that are conveniently located at either side of the junction boxes.

Is the Hayward h300fd propane or natural gas?

Hayward H300FD Natural Gas or Propane Pool Heater The H300FD is a mid-sized pool heater from the Hayward H-Series, with 300,000 BTUs and an electronic ignition system. These models can run on either natural gas or propane.

It’s a 1016-405 Series Direct Spark Igniter, but you need to pay attention to the part number on the white paper sticker, it is a 1016-458 variant.

How to troubleshoot a Hayward Universal pool heater?

Troubleshooting chart for Hayward Universal H-Series electronic pool heaters with a digital display, models H150, H200, H250, H300, H350, H400 INPSECT WIRES FOR KINKS OR RODENT DAMAGE. INSPECT TERMINALS FOR BREAKAGE OR CORROSION REMOVE WIRES AND MEASURE OHMS WITH PUMP ON; IF CLOSED – SWITCH IS OK. IF OPEN, RECONNECT WIRES & PROCEED.

What causes a Hayward h400fdn to go out?

If the units lights, but then goes out about 4 seconds or less, you probably have a flame sensor issue. If it never lights, probably a igniter issue. However, it could also be a bad igniter control board. Go to this site and download the manual, if you don’t have it.