What kind of power does a Yaesu transceiver have?

This transceiver covers the HF/50 Mhz bands, is capable of 200 watts of power, VC Tune for the Main and Sub Band included, along with Crystal Roofing Filters for CW (300 Hz Main only/600Hz), SSB (3 Khz), and AM (12 Khz) makes this the ultimate radio.

How big is the FM radio on my ft-950?

That means if the radio is on 14.160MHz, I can see anything going on from 14.112Mhz thru 14

Can a ft-950 be hooked up to a computer?

But at least you get a serial cable to hook up the FT-950 to either the computer or SDR-IQ. This is if you didn’t hook up the radio to the computer for control (CAT) To get at where you have to install the IF-2000 in the FT-950, remove all the many screws (except the feet) that hold on the bottom cover on.

Where do I put the if-2000 in my ft-950?

To get at where you have to install the IF-2000 in the FT-950, remove all the many screws (except the feet) that hold on the bottom cover on. Once removed you will see this void with the taped wire. That is where the DMU would go. Bah! We’re putting the IF-2000 there instead. Look at that pretty board installed.

How to reassemble a Yaesu ft-950 extended TX radio?

Discussion in ‘ Yaesu ‘ started by Moleculo, Jul 20, 2010 . Turn the radio over and take off the back cover. Locate the control board (Right front corner) you will see 9 jumpers, marker 1 through 9. add a Solder bridge to pad number 5 . See the attached picture for details Reassemble the radio.

What do you need to know about the ft-950 cat?

FT-950 CAT OPERATIONREFERENCEBOOK CAT(COMPUTERAIDEDTRANSCEIVER)OPERATION OVERVIEW The CAT (Computer Aided Transceiver) System in the FT-950transceiver provides control of frequency, VFO, memory, and other settings such as dual-channel memo- ries and diversity reception using an external personal computer.