What mode should I keep my hot tub on?

By default filter modes are 2 hours in the morning and 2 hours in the evening, the rest of the time the hot tub will use the insulation to keep the spa warm and retain heat. Economy is a good setting for those who use the hot tub daily.

Does economy mode on hot tub save money?

Preventing Expensive Energy Bills Many spas also come equipped with a hot tub economy mode, which can help you reduce your costs. Look out for hot tubs with unnecessary features, as these can increase your electric bills.

Is there an error code on my Sundance Hot Tub?

My Sundance Certa 780 Series hot tub is showing an error of FL1. I went through the manual diagnostics and the error is still there. I contacted Aquatech and they suggested I clean the filter with the FilterBrite. In the first 4 years we basically used one filter and never got this error message.

Why is my Sundance spa not flashing FL1?

If this does not correct the flashing FL1 msg you could have a blockage in the circulation line or at the flow or psi switch or you could have a bad connection at the flow or psi switch or a bad flow or psi switch. If all else fails contact our Service Support Desk to book a diagnostic and repair of your Sundance Spa.

What to do if your waterfall is not working?

One of the wall grates would be a prime candidate. Then fill the pump basket up as much as you can (it shouldn’t fill up) and put the lid back on it. Then run the pump and see if it primes. If it does, switch the valves on the “not sure” lines one way and then the other.

Is there a waterfall in my swimming pool?

Hi, we have a waterfall in our pool that runs off a Hayward Flow Max II pump. Tried to turn the waterfall on today and nothing. Went out there to check the pump, and it had just about 2 inches of water in it. The pump was on and it sounded like it was running.

How can I tell if my Sundance Spa is having problems?

The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter. 2. Defective Circ Pump or Flow Switch: Need to check for Circ Pump operation. Is there voltage going to pump, Is there adequate Flow coming out of Heater Port in Spa?