What should I do if my gas range igniter is not working?

If the burner is in the correct position, but the gas is still not igniting, check to make sure the porthole is clear by inserting a needle into the hole. If the spark igniter lights the burner but does not stop clicking, the igniter electrode is likely dirty, and the metal rod of the electrode should be scrubbed clean.

What are the igniters on a gas cooktop?

Gas cooktops are usually either sealed or twin burner models. Sealed burners have an igniter for each burner. All of the igniters operate on a single spark control. In a twin burner cooktop, which is found on some lift-top units, there are two igniters; one for the left side burners and one for the right.

What to do if your dryer ignitor does not ignite?

If the ignitor glows but fails to ignite a flame inside the burner assembly, check for a blown high-limit thermostat or thermal fuse. The flame sensor mounts on the side wall of the burner assembly, close to the ignitor. The flame sensor opens the gas valve once the ignitor glows hot enough to ignite the gas.

What causes a gas stove burner to not ignite?

If the igniter sparks and ignites the gas, the problem was a detached wire. Alternatively, if the wires are attached and the igniter doesn’t spark, the igniter is faulty and has to be replaced. Proceed with troubleshooting igniters that spark but a burner doesn’t ignite. Turn on a burner knob halfway.

When do you replace the burner igniter switch?

Replace the burner igniter switch if the burners don’t spark when you turn the burner control knob to the Lite position or if igniters spark constantly even when the burner knobs are in the Off position. When a range stovetop burner igniter won’t click or if it clicks constantly even with the burner off, the igniter switch could be the problem.

Why does my stovetop burner igniter not click?

When a range stovetop burner igniter won’t click or if it clicks constantly even with the burner off, the igniter switch could be the problem. This DIY repair guide shows how to replace the range spark igniter switch. Find the perfect fit for your refrigerator.

Where does the gas go in a direct ignition furnace?

The gas valve sends gas to the main burner(s), which is lit by the pilot light. If you have a direct ignition furnace, you won’t have a pilot light. These furnaces skip steps 3-5 and instead light the burner directly. Your furnace will still have a flame sensor, but it will be over the burner’s flame.

How can I troubleshoot my Bosch tankless water heater?

If the tankless water heater develops a problem, troubleshoot it before calling for service. Disconnect the power supply to the water heater before removing the cover. Inspect the water supply. Connect the supply line to the blue inlet on the water heater.