What should I do if my hot tub wont turn on?

Turn on the lower amp breaker first if you have a hot tub powered by 240 volts. If it is 120 volts of household power, simply unplug it and then plug it back in after a couple of minutes.

Why does my hot tub control panel keep blinking?

If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.

Can a hot tub control panel be replaced?

Replace the control panel – If all else fails with your control panel then you might need to just bite the bullet and replace it. The process of replacing a control panel is relatively easy as they are essentially plug and play, you just need to make sure that you get an exact replacement.

What should I do when filling up my hot tub?

Check for water leaks at couplers on pumps and heater housing. Hand tighten if necessary. 10. Turn temperature on the command center (on equipment system on models without a command center) to maximum level. Periodically check temperature of water to until desired temperature is reached. Reduce thermostat setting until HEAT light turns off. 11.

How do you turn off a hot tub?

Check the thermostat to ensure it is in the “Off” position. Turn off the hot tub breaker inside your home’s main breaker panel. If your hot tub has a disconnect switch between the main breaker panel and the hot tub, place the switch in the “Off” position. Place the end of your water hose into the hot tub.

What happens if I refill my hot tub?

NEVER refill your hot tub with hot water—this will affect your sensors and send your electrical system on the fritz. 10) Turn the equipment back on once the spa is full (about 1 ½ inches above the highest jet). Turn on the power, heater, and jets to purge any lingering air from the plumbing.

Where is the reset button on a hot tub?

Turn on the hot tub breaker inside the main breaker panel and place the disconnect switch in the “On” position. If your spa pack includes a ground fault circuit interrupter (GFCI) or if your disconnect switch or circuit breaker features a built-in GFCI, push in the “Test” button. This action should make the “Reset” button pop out.

What happens when a hot tub high limit switch is tripped?

A tripped switch cuts the power BEFORE the fuse to stop the function of the heater as well as the hot tub pump. In older systems, this may only cut power to the heater when tripped. The high limit switch senses the water temperature with a capillary tube that is then attached to a bulb.