What to know about Balboa vs spa control systems?

Below is a comprehensive list of our Balboa VS Spa Control Systems, a general description, and the system’s circuit board, heater, and panels that each of the systems work with. If you are attempting to replace parts within your VS spa control system, this should assist you in locating the replacement parts for your product.

What is the installation manual for a Balboa spa?

End User Warning This Installation Manual is provided solely to aid qualified spa service technicians in installing spas with control systems manufactured by Balboa Water Group. Balboa controls have absolutely no end user serviceable parts.

Where are the sensors on a Balboa hot tub?

Note: The below images refer to a Toronto Spa for the location of the control system. Placement varies from spa to spa, but in any case it will be located along the same side of the hot tub as the main control panel. Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).

How to reset the sensors in a Balboa bp501 control system?

Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below). Step 4: Disconnect the sensor wires from the circuit board.

How to check spa panel messages on Balboa direct?

1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below. If there is Now an Error Message, select Message Other than CrC or CHKSUM FAIL below.