What was the name of the American standard toilet?

1929 – American Radiator & Standard Sanitary Corporation. 1948 – American Standard brand name. 1967 – American Standard company name. Products are often simply marked – “Standard.” Up to through the 1950s, model numbers often had an “F” prefix such as “F4043.”

Where do you find the model number on an American toilet?

American Standard One-Piece Toilet models usually begin with “2xxx” and will usually have the model number stamped inside the tank or under the lid. Please use this helpful toilet model chart to help find genuine replacement parts. American Standard Two-Piece Toilets usually post the corresponding Tank Number under the lid or inside the tank.

How many gallons does an American standard toilet flush?

American Standard H2 Option gives you the option to either use 0.92 or 1.28 gallons per flush. The 0.92 gallons if for flushing liquids while you use the 1.28 gallons full flush to flush away the solids. As a result, the H2 Option is compliant with both EPA’s WaterSense and the California Green Building Standards Code (CalGreen).

What’s the difference between American Standard and American Standard faucet?

The word “standard” and “American Standard ® ” are NOT identical. Most of their faucet parts will only fit their brand (as is the case with their competitors as well). Many of their toilet parts will only fit their brand of toilet. Not all of American Standard ® parts are universal (“standard”).

What is the model number of an American standard toilet?

American Standard Complete listing of every American Standard available toilet by model. We have set up this page in two sections, complete toilet model number and toilet tank number. American Standard One-Piece Toilet models usually begin with “2xxx” and will usually have the model number stamped inside the tank or under the lid.

How much water does a toilet in 1980 use?

A toilet manufactured before 1980 might use 5 to 8 gallons per flush (gpf), which means that each of the home’s residents might be flushing 48 gallons of water down the drain daily. By contrast, a toilet built to 1992 standards uses 1.6 gpf, and the average flusher uses about 9.1 gallons of water daily.

When did they start using the standard toilet tank logo?

This logo was used from mid 1930s?-1946. For cast iron fixtures, the logo says “Standard”, with a small S, and is molded in. It is unknown if this was used during this time period. Different logos were used in toilet tanks at different times.

When did the American Standard Radiator come out?

1899 – Standard Sanitary Manufacturing Company. 1929 – American Radiator & Standard Sanitary Corporation. 1948 – American Standard brand name. 1967 – American Standard company name. Products are often simply marked – “Standard.”

What to use to replace worn out washer in faucet?

Planning Your Attack. Now that you’ve determined that you have a compression faucet with a worn-out washer, you’ll need a few tools before going to the hardware store: Adjustable pliers, flathead and Phillips screw driver, and scratch-prevention cloth.

What’s the best way to replace a washer?

Before installing the washer in its base, clean away any mineral deposits. Secure the washer with the brass screw, then carefully and methodically reassemble the stem and replace it into its slot. Use the pliers to completely tighten the reassembled parts. Turn on the water supply and test your handiwork.

How do you replace a toilet seat American Standard?

Unscrew the thumb screws on the lever assembly and slide the lever assembly out from the square hole in the top of the plunger. Pull the old plunger straight up out of the body of the fill valve. With a seat tool, unscrew and remove the old seat directly underneath the plunger. Screw in the new seat until it is snug.

Are there universal parts for American Standard toilets?

Most of their faucet parts will only fit their brand (as is the case with their competitors as well). Many of their toilet parts will only fit their brand of toilet. Not all of American Standard ® parts are universal (“standard”).