What would cause a lawnmower not to get spark?

When it does fail, it is usually due to heat caused from improper wiring of the ground wire to battery voltage. If the engine does not produce spark, other areas of the ignition system should be checked before focusing on the ignition module as source of failure (see above).

How do you test a ignition switch?

Put the ignition key into the ignition switch and crank the engine. If the engine cranks, then your ignition switch is obviously working fine. If the engine does not crank, and you hear a “click” when you first turn the key to the “III” position, then your ignition switch is not the problem.

Why is my Cub Cadet not getting fuel?

So you should get a flow from it as long as the line is lower than the outlet unless the fuel line or the fuel outlet of the tank is plugged. Check for trash in the tank as being the most likely. And as inexpensive as fuel line is I would replace it rather than try to clean it.

How long does it take for gas to go stale in Cub Cadet?

Whether in a container or in your unit, gas can go stale and lose its volatility in as little as 30 days. Drain suspect fuel completely from the unit’s fuel system and replace it with fresh fuel. (Make sure to properly dispose of the old fuel.)

Why does my Cub Cadet tractor rock forward?

Many hydrostatic transmission problems on a Cub Cadet tractor are due to a transmission control rod misalignment. The transmission control rod causes the tractor to rock slightly forward or backward when the engine is powered high idle speed while it is in neutral.

How to troubleshoot the hydrostatic transmission in a Cub Cadet?

How to Troubleshoot the Hydrostatic Transmission in a Cub Cadet. 1 Step 1. Set the front of the tractor against a stable post or wall that is in a fixed position. The object the tractor is leaning on must not move. 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.

Why are there so many problems with my Cub Cadet?

Some may have to do with the engine itself, others may have to due with other systems that the engine interacts with, such as; electrical starters and safety interlock systems that will vary by product design.

Is the Cub Cadet 1862 W / Kohler M18 no spark?

Cub Cadet 1862 w/Kohler m18 NO SPARK, but turns over. | LawnSite™ is the largest and most active online forum serving green industry professionals. Cub Cadet 1862 w/Kohler m18 NO SPARK, but turns over.

How to know if your engine has no spark?

First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.