What year is VY Commodore?

2002
The Holden Commodore (VY) is an executive car that was produced by the Australian manufacturer Holden from 2002 to 2004. It was the third iteration of the third generation of this Australian made model.

How do I remove a Blaupunkt radio?

Press the faceplate release button located on the lower left corner of the Blaupunkt stereo’s face. Remove the face from the stereo deck and set it aside. Place the stereo removal tools into the holes at the bottom corners on the stereo.

How do I remove Vy dashboard?

Take out the side caps from the dash Calais models have cruise control panel and remove the screws. Lift off the top section of the dash above the gauges. Using a Philips head screwdriver, poke it up through the air vents on the side and unscrew the two screws. Remove the air vents.

How do I change the controls on my VY steering wheel?

Re: Replacing VY Steering Wheel Stereo Controls Disconnect the wiring and remove the airbag. Remove the large nut in the middle of the wheel to remove the steering wheel and unplug the wiring for the controls as you take it off. Remove the old controls and replace them with the new ones then reverse the process.

What’s better VY or VZ?

Its V6 engine can only hold as much as 3.6 L, as opposed to the VY’s 3.8 L of the same engine version. The VY is the earlier car series compared to the VZ, which was launched two years after. 2. The wagon models of the Commodore VY have 5 doors compared to the wagons of VZ, which only has 4 doors.

What does VY P car mean?

P/car stands for Passenger Car.

How do you get a stuck car stereo out?

First, turn your car off if it isn’t already. While the car is off, hold the power and the eject button. Press your CD player’s power and eject buttons down at the same time, holding them for about ten seconds. If your stereo has a “force eject” feature, it should spit out the CD.

What’s the best way to replace a car stereo?

1 Replace Your Car Stereo in 7 Steps. A blank space in the dash and a bunch of loose wires are enough to significantly upgrade the kinds of things your car can do. 2. Slide removal tools into the slots on the radio’s face. 3. Connect the car’s wiring to the adapter harness.

How to install a single Din car stereo?

How To Install a Car Stereo (Single & Double DIN) | Car Audio 101 1 Disconnect the Car Battery 2 Remove the Factory Car Stereo 3 Prepare the Car Stereo to be Installed 4 Run Additional Accessories (Bluetooth Mic, Satellite Radio, etc) 5 Install the Car Stereo

What do I need to upgrade my Chevy stereo?

You’ll need a mounting kit to trim out the new stereo, a wiring harness that allows you to connect it without having to cut the factory wiring, and an antenna adapter that connects the Chevy antenna plug to your new radio. Crutchfield includes these installation parts at a very deep discount with your receiver order.

What kind of key do you need to remove a stereo?

If the stereo isn’t held in place by screws or nuts, you’ll need to use a radio-removal key. This tool is commonly necessary in Ford vehicles. Radio-removal keys (sometimes also referred to as radio-removal tools) will typically either be in an elongated horseshoe shape or will have a circular shape at one end and a notched shaft at the other.

How to remove a Holden VY-VZ factory radio aka Chevrolet?

This is how to remove a factory radio from a Holden VY – VZ.New video here –

Is there a replacement stereo for a VZ Adventra?

Replacement Stereo for VZ. Options? – Car audio My wife has a VZ Adventra which has the standard Blaupunkt double DIN stereo. Not sure what happened to it, but it’s glitchy as hell. A lot of button presses don’t register and it’ll randomly change radio stations. Anyway, it drives her (and me) crazy.

How to remove a radio from a scooter?

Coathanger in…radio out. Slide them in until the click. Lean them out and pull forward as you do it. You put you left foot in, your put your right foot in , you take your left foot out and you slide it all about! i can relate to OP if i was smashed and my mates had a scooter the last question id be askin is whose is this?

How to remove a radio from a Commodore?

Tasmaniak Not a valid input…. Coathanger in…radio out. Slide them in until the click. Lean them out and pull forward as you do it. You put you left foot in, your put your right foot in , you take your left foot out and you slide it all about!