When did the Mercedes Benz Sprinter come out?

In this article, we consider the second-generation Mercedes-Benz Sprinter (W906, NCV3), produced from 2006 to 2018.

What kind of valve actuator does a sprinter have?

This electrical valve actuator is popularly at fault with the Mercedes Sprinter model and your dealer will have sold hundreds of this item over time. It has a single two wire electrical plug connected to it and three rubber pipes; in some cases its pipe locations are even marked: IN – OUT – VENT.

Where are the fuses on a Mercedes Sprinter?

Here you will find fuse box diagrams of Mercedes-Benz Sprinter 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017 and 2018, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

How does a Mercedes Sprinter turbo engine work?

Stationary engine, rod fully extended, vanes in no charge position. Start engine, rod pulls lever downward slowly, vanes full charge position. Rev engine, rod moves in and out during the rev cycle, vanes apply variable charge through rev cycle – Audible howl from air box.

Where is the power increaser on a sprinter?

Once determining that the plug release tab was on the left side of the plug, the removal and installation became more manageable installed module on our 2008 sprinter Navion motorhome w/42k miles. Increase in power & torque were immediately noticeable on 1st drive after install,made it fun to drive.

In this article, we consider the second-generation Mercedes-Benz Sprinter (W906, NCV3), produced from 2006 to 2018.

How does the battery system work in a Sprinter campervan?

When the van is running, a smart controller connects our alternator power to our house batteries. This helps keep our batteries charged up while driving. The controller automatically disconnects to protect the starting battery in the event the house batteries were to run low. An inverter allows you to have 110V outlets like you see in your house.