When does the date slicer start and end?

But its start and end date are always January 1st, 2015 and December 31st, 2019, regardless of the filter on years. What could do the trick? Solved! Go to Solution.

Why does slicer not sync on using button feature?

Slicers have been used as dropdown and are synced to other reports as well. When the button is clicked, it opens the page linked, but the slicer on the page linked turns into default type instead of dropdown. I am facing this issue after April update of desktop and online versions.

What to do if your globe slicer stops running?

Dirty knife edge – Clean the top and bottom edges of the knife. If the slicer stops running on select Chefmate series models (C9/10/12), the motor could be overheated. Give the unit 10-15 minutes to cool down before pushing the reset button. Then, start the slicer.

What happens if a module is not loaded in slicer?

If a module is not loaded in Slicer (ignored or failed), all dependent modules won’t be loaded. You can verify the dependencies of a module in the tooltip of the module. You can filter the list of modules by untoggling in the advanced (>>) panel the “To Load”, “To Ignore”, “Loaded”, “Ignored” and “Failed” buttons.

What to do if your globe Slicer has no power?

No power – See if the slicer’s power cord isn’t plugged in. If that isn’t the problem, check if the circuit in the power box needs to be reset or if the fuse is broken. Knife cover is off – On select slicers, except C9/10/12 and GC9/10 models, the knife cover might have been removed or improperly installed.

Why does my electric slicer keep losing power?

If you own an electric slicer, as with most electronic devices, the power connection is the key thing to keep it working. It is also something that can easily give you problems. When you have a loss of power check the outlet, the cords, and connections. You can do this systematically.

What causes the cursor to change to a picking hand in slicer?

Mousing over any “pickable” object in any of Slicer’s viewers will cause the cursor to change from a “pointer” into a “picking hand”. When the cursor shows a picking hand, left-clicking and dragging the mouse will pick and manipulate the object.

What happens when Prusa slicer does not start?

When Prusa Slicer starts up, the window opens and then tries to render the platter using OpenGL. The rest of the window should still be functional and you should be able to open Help-About and Help-SystemInfo. Did you install slicer manually or use the installer included with the driver install set?