Where do two internal sloping surfaces meet?
Where do two internal sloping surfaces meet?
Valley. The junction of two inclined roof surfaces at an internal angle to provide water run-off; channel to allow roof slopes at different pitches to join together and discharge water into gutters.
What is the trim around a roof called?
Fascia: Vertical roof trim located along the perimeter of a building, usually below the roof level, to cover the rafter tails at the eaves and to seal off the top of the siding along the rake; also called gutter boards.
What do you call the sloped edge of a roof?
Roof rafters are the main supports of a roof. Lisa S. / Shutterstock.com The sloped edge of a roof over a wall is the rake. The squared-off end of a sloped roof is called the “rake.” The ridge is the horizontal peak of the roof. Elk Roofing
Which is the upper part of a roof?
Gable: The upper part of a side wall (or flank wall), usually triangular in shape, that comes to a point at the ridge of a sloping roof. Rafters: sometimes referred to as common rafters, these inclined lengths of timber rise from the eaves at the bottom of the roof to the ridge apex at the top.
What’s the name of the wood at the intersection of a roof?
The wood member at the intersection is called the valley rafter. A junction where a pitched roof surface adjoins a wall or similar structural feature. This is commonly seen in roof and building extensions.
What are the different types of roofing materials?
Pitched roofs are typically made of shingles (asphalt, composite, wood, cedar, slate, or metal), or standing seam metal. The aforementioned styles – gable roofs, hip roofs, jerkinhead roofs, mansard roofs, gambrel roofs, and saltbox roofs – are all pitched roofs. Types of Roofing Materials
What is the bottom edge of a sloped roof called?
The bottom edge of sloped roof surface is called as eaves from which rain water is drops down during raining. 7. Hip Hip is a place where two sloping surfaces meet, where exterior angle is more than 180 o. 8. Hipped end At the end of a roof sloped triangular surface is formed which is called as hipped end. 9. Valley
What do you call the end of a roof?
At the end of a roof sloped triangular surface is formed which is called as hipped end. 9. Valley It is also a place where two sloping surfaces intersects but the exterior angle is less than 180. 10. Verge Verge is the edge of gable roof which runs between ridge and eaves.
Which is the most common part of a roof?
What are the common parts of a roof? Roof Ridge: The roof ridge, or ridge of a roof is the horizontal line running the length of the roof where the two roof planes meet. This intersection creates the highest point on a roof, sometimes referred to as the peak. Hip and ridge shingles are specifically designed for this part of a roof.
The wood member at the intersection is called the valley rafter. A junction where a pitched roof surface adjoins a wall or similar structural feature. This is commonly seen in roof and building extensions.