Where does the ARP wire go in a Dometic control box?
Where does the ARP wire go in a Dometic control box?
The ARP yellow wire is connected to the screw terminal where the power wire was removed in the last step. (4) This is the Dometic control box, see (3) for wiring. Also, it is a good idea to either use an in-line fuse or an ARP Circuit Breaker in-line with the power supply to the control box.
Where does the + 12VDC go in the Dometic controller?
The +12VDC is run directly to the Dometic controller for this drawing. (1) Starting at the RV, the RV delivers power to run the fridge and its controls. Please note that two wires will enter the cooling unit compartment, one power and the other ground.
What are the different wiring schemes for Dometic?
The following Dometic wiring schemes are provided so that the installer can easily identify the factory wiring scheme. Each wiring scheme is numbered for ease of communication if telephone or e-mail installation assistance is needed.
How do you connect a fridge to a Dometic control box?
(3) Always start wiring by disconnecting the power to the fridge, this can be done by removing the fuse. The next step is to connect the ARP ground.
Where to find the thermal fuse in Dometic dm2652?
Ceeminor, the thermal fuse I’m familiar with looks like a resistor, connected via spade terminals, with a clear plastic tube to protect from short circuits. This is represented in your schematics by item “Y”. Item “F”, I have no experience with. Item Y should be found close to the firebox. Thanks for the info!
The ARP yellow wire is connected to the screw terminal where the power wire was removed in the last step. (4) This is the Dometic control box, see (3) for wiring. Also, it is a good idea to either use an in-line fuse or an ARP Circuit Breaker in-line with the power supply to the control box.
Where does the wire go in a thermofuse?
I chased the wire from the 12VDC terminal block all the way into the inside of the back of the refrigerator and lose it there as I can’t see the interior part of the refrigerator. The box that has the fire inside. Base of the chimney stack. Thanks for everyone’s help!
(3) Always start wiring by disconnecting the power to the fridge, this can be done by removing the fuse. The next step is to connect the ARP ground.