Where is the brake light relay located?

A brake light switch is a small electrical relay attached to the brake pedal. It is typically installed above the brake pedal and (hopefully) activated every time your pedal is pressed.

Is there a relay for tail lights?

Your rear lights are controlled through the same switch that controls the headlights. Power is channeled through a relay to the rear lights, illuminating them when the switch is engaged.

What causes the brake lights not to work?

If one or more of your brake lights isn’t working properly, it could mean one of three things: The brake light system fuse is blown, the brake light bulbs are burned out or the brake light wiring switch is broken. All of these issues are easy to troubleshoot.

What are the tail lights on a PT Cruiser?

Restore both with a tail light assembly replacement for Chrysler PT Cruiser from AutoZone. Your Cruiser tail lamp assembly houses the rear lights that are engaged when you brake, signal a turn or go into reverse. They give a clear and bright view to other drivers to promote safe driving.

Where is the fuse box on a Chrysler PT Cruiser?

A description of each fuse and component may be stamped on the inside of the cover. The fuse access panel is on the left side of the instrument panel next to the steering column. To remove the panel, pull it out, as shown. A label identifying the components and circuits is located on the inside of the cover.

What are the problems with a 2007 PT Cruiser?

Unfortunately, engine lights that will not turn off seem to be a prevalent PT Cruiser problem. The common symptoms for the 2007 PT Cruiser are overheating accompanied by the engine light turning on. The code P0340 is often displayed as the problem for owners.

Can a broken brake light switch cause an accident?

The brake light switch can fail over time and, when that occurs, the brake lights will not switch on. Without the brake lights you can easily cause an accident. You may also find yourself getting ticketed and having to pay fines. Always check the brake light bulbs first for damage because if they are broken it will mimic a bad switch.

What are the relays on a PT Cruiser?

Fuses and relay Pt Cruiser R1 Horn relay R2 Starter motor relay R3 Fuel pump relay R4 AC compressor clutch relay R5 Battery current saving relay

Where are the fuses located on a PT Cruiser?

Underhood Fuses Pt Cruiser (Power Distribution Center). fuse box location. A Power Distribution Center is located in the engine compartment; next to the air cleaner filter. A label identifying the components and circuits is located on the underside of the cover. Identifying fuse box (per 2005). R1 Horn relay R2 Starter motor relay R3

Where is the head lamp on a PT Cruiser?

(10A) Engine management, ignition switch, instrument panel, transmission control module (TCM) (10A) Head lamp adjustment switch, head lamp level control module, head lamp low beam, left