Where is the pilot light on my Glow Worm?

It is on the kitchen wall with a flue straight out horizontally from it. 2 days ago, the pilot light went out and would not re-light, so I have no hot water or heating, only hot water now with the immersion. I asked a local retired engineer to help me and he was for an hour or so, kindly checking it.

Why is my Glow Worm fuelsaver 50B boiler not working?

Also the overheat interupter device on the boiler, was ok and not at fault. After checking all these (without the boiler manual as I could not find it) he said the only other thing he could think of was the gas valve to be faulty (solenoid inside), but they cost about £100.

What is the fault code on a flexicom glow worm boiler?

Fault code F14 (Flexicom CX range) If you were to look at the service manual, you’d find this fault states there’s a defective gas valve. However, check there is power from the PCB to the gas valve. If not, it’s not the gas valve at all, but either the PCB or the wiring harness.

What does fault code F16 mean on glow worm?

1. Fault code F16 (Ci models) If the code F16 flashes up on your Glow-worm Ci model, this indicates a flame detection fault with your boiler. It could very well be that the boiler itself requires a service, and the probe needs cleaned or replaced.

What to do if your pilot light wont work?

First, locate the thermocouple to clean it using a piece of sandpaper. Always remember to shut off the gas before you start cleaning and to make sure that your thermocouple is cool. If you’re thermocouple still doesn’t work after cleaning, the issue may be that it’s bent.

What to do if your hot water heater pilot light won’t stay lit?

If you have followed these steps and your water heater pilot light won’t stay lit, you may need professional help to fix the problem, give All Masters a call if you live in Arlington TX, and we can fix any of your hot water heater thermocouple or pilot light issues!

Where to find glow worm fuelsaver 50B boiler?

Discussion in ‘ Plumbing and Central Heating ‘ started by stephentanner, 5 Aug 2010 . I don’t know if anyone can help me? I have an old boiler, it is a Glow worm Fuelsaver UFB 50B model. It is on the kitchen wall with a flue straight out horizontally from it.

What’s the problem with my Glow worm boiler?

2 days ago, the pilot light went out and would not re-light, so I have no hot water or heating, only hot water now with the immersion. I asked a local retired engineer to help me and he was for an hour or so, kindly checking it.