Where is the reset button on a Westinghouse furnace?
Where is the reset button on a Westinghouse furnace?
Press and release the raised red button at the center of the flame roll-out switch to reset the furnace. You can press the reset button up to three times before troubleshooting the furnace’s internal components or calling for repair service; allow 30 minutes between each reset.
What should I do when I light the pilot on my furnace?
Turn the gas control dial to “off” and wait five minutes. This is a safety procedure to make sure there is no residual gas in the furnace when you light the pilot.
Where is the thermocouple on a furnace pilot light?
No matter the pilot configuration, the thermocouple will be near the burners—look for a removable metal rod nearby. Locate the copper rod near the burners. This is the thermocouple. If you look very closely, you’ll find the thermocouple tucked in behind the burners.
Where is the pilot nozzle located on a furnace?
Locate the pilot nozzle, which is mounted within the pilot valve body near the control valve. Replace the front access panel when your are finished.
When does a gas furnace go into lock out?
Gas furnaces with pilot lights will go into lock out if the pilot light goes out or if the pilot light fails to light up the main burner. Furnaces also include limit switches that monitor fuel pressure and the internal temperatures of the heat exchanger.
Turn the gas control dial to “off” and wait five minutes. This is a safety procedure to make sure there is no residual gas in the furnace when you light the pilot.
No matter the pilot configuration, the thermocouple will be near the burners—look for a removable metal rod nearby. Locate the copper rod near the burners. This is the thermocouple. If you look very closely, you’ll find the thermocouple tucked in behind the burners.
Locate the pilot nozzle, which is mounted within the pilot valve body near the control valve. Replace the front access panel when your are finished.
Gas furnaces with pilot lights will go into lock out if the pilot light goes out or if the pilot light fails to light up the main burner. Furnaces also include limit switches that monitor fuel pressure and the internal temperatures of the heat exchanger.