Why does my pool GFCI keep tripping?

Motors have vents in the back and a fan that cools them. This same fan can suck in moist air and cause the GFCI to trip. You don’t want to block the vent just keep it from taking on excessive moisture. -If the breaker trips as soon as you turn it on and the pump area is dry then you may have a bad breaker or motor.

What to do if your Hayward pool pump goes bad?

Check capacitor for …capacitance or resistance with an Ohm meter. If breaker still trips, replace the breaker; they go bad eventually. If your Hayward pump runs for only 5 seconds and shuts off, check the incoming voltage. Most inground Hayward pumps are shipped to accept 230V, and if you only give it 115V, it can’t get up to speed.

Why is my Hayward pump Tripping the Breakers?

I did a little web research and found that the part is a HARWIL Q-12DS FLOW SWITCH. There is current running through it and if it is shorting then the GFCI is doing its job by tripping the breaker. I’m thinking that if the impeller turns fine then I may ensure the wires are seperated so they can not short out and try it again.

What kind of voltage does a Hayward pool pump take?

If your Hayward pump runs for only 5 seconds and shuts off, check the incoming voltage. Most inground Hayward pumps are shipped to accept 230V, and if you only give it 115V, it can’t get up to speed.

Do you still need Hayward pumps and filters?

We carry the other brands, but Hayward pumps and filters have always been our flagship line. Reliable & durable, Hayward pumps will still likely need some type of troubleshooting at some point during your relationship.

How to troubleshoot a Hayward Super pump motor?

Once the pump is drained out you will want to remove the four 9/6 bolts that connect the Hayward Pump housing to the motor bracket. Once you do this pump housing will separate from the motor end of the pump and you will now see the impeller. Grab hold of the impeller and turn it counter clockwise until it spins off of the pump motor shaft.

Which is the best Hayward swimming pool pump?

One of their most popular lines of swimming pool pumps is called the Hayward Super Pump. This pump is offered in both the Super Pump Standard and The Super Pump II. The Super pump is installed in millions of backyards all over the world and is well known for its long lasting life.

How big is the inlet on a Hayward Super pump?

There are two fitting connections on the Hayward Super Pump housing. These inlets can be either 1.5″ inches or 2″ inches depending on the horsepower and size of your super pump. You will need to connect both side of the pump to your swimming pool system.

How long does it take to replace a Hayward pool pump?

Things like the mechanical pump seal, pump bearings, pump gaskets and so on will have top be replaced along the way. Most of these things can be repaired in a few hours with replacement Hayward parts that are generally sold at your local swimming pool supply store.