Why does my Worcester boiler keep saying reset?

Some of the most common boiler faults which could be triggering the need to reset it frequently include: A leak in the heating system. A blocked plate heat exchanger. An electrical part is faulty and needs replacing. If your Worcester boiler is leaking, this can cause low pressure and the boiler to lockout.

Are there any problems with the Worcester Bosch Greenstart 18ri?

Discuss Worcester Bosch Greenstart 18ri problems in the Gas Engineers Forum area at PlumbersForums.net Not open for further replies. new to this forum hope you can help, I have a WB Greenstar 18ri noticed no hot water and when tried to fire up heating the blue light was on however no green light at the heater.

What happens when you reset a Worcester Bosch Greenstar boiler?

When the boiler resets the mains indicator will no longer be flashing and the boiler will function normally, dependant on the programmer and room thermostat settings. A reset fault condition will exist If the electrical power to the boiler has been interrupted.

When did my Worcester Bosch 18ri boiler come in?

Water is flowing ok both upstairs and kitchen, switched gas system off and switched on immersion to test hot water boiler all working and I have hot water. My basic so far. I do think it is the boiler although only fitted in April 2008 and was serviced in Jan this year.

What should I do if my ri boiler wont turn on?

Worcester suggest turning off the boiler, unplugging from the mains and then firing it back up after a few seconds. This acts as a basic reset for an RI boiler. Same as the “no green light” LED failure explanation above. Same as the “no green light” PCB failure explanation above.

How to relight a Worcester Greenstar boiler, boiler work?

3 In case of a fault, you will find the blue mains indicator light to be flashing. 4 1) To begin resetting your system, you need to turn the central heating temperature knob anticlockwise to the RESET position and hold for around 5 seconds and then turn the knob back to the original temperature setting.

How do you reset a Worcester Bosch boiler?

Resetting a Worcester Bosch boiler in this case means turning the dial down until it reaches the reset light, holding it there for 3 seconds – make sure to turn it back afterwards.

How often does the reset button flash on a GreenStar boiler?

In case of a fault you would find the reset button to flash once per second and the blue indicator light to be continuously flashing. To reset the system you need to press the reset button for approximately 5 seconds.