Info

The hedgehog was engaged in a fight with

Read More
Tips

Why has the clock on my boiler stopped working?

Why has the clock on my boiler stopped working?

There are a few reasons your timer clock may have stopped working. The clock resetting due to the power being out for a while (especially if you have an older boiler) A blown-out fuse. Your room thermostat settings telling the boiler not to come on.

How do I reset my Worcester 24i junior boiler?

In the event of a fault, the reset button will flash once per second and the blue mains indicator light will flash. 1. To reset the boiler press the reset button for approximately five seconds. When the boiler resets the reset button will no longer be illuminated.

How to replace boiler timer on Worcester 24i?

The Clock timer on the 24i pops out from the front. You dont need to remove the white metal front case, nor any other case… its done fro the gray panel at bottom. There are three wires that connect at back of timer. make sure boiler power is turned off. make a note of where the wires go.. .disconnect, reconnect new timer.. . Bingo..

Do you need a gas safe to use a Worcester Bosch clock?

21 of 23 ( 91%) reviewers would recommend this product. All Boilers and Boiler Accessories must be installed by a Qualified Gas Safe Registered professional. An easy to use analogue clock for setting heating time periods. For use with I, Si Combi and CDi combi only. Add to basket for…

Is the Worcester Bosch single channel TimeClock compatible?

You can indeed. This timer is compatible, or the MT10RF would be also if you want it to keep it wireless. 0 of 0 found this answer helpful. Was this helpful?

Why does the timer on my clock stop working?

There are a few reasons your timer clock may have stopped working. These include: Your old mechanical clock not automatically catching up with seasonal clocks changes. The clock resetting due to the power being out for a while (especially if you have an older boiler) A blown-out fuse.

The Clock timer on the 24i pops out from the front. You dont need to remove the white metal front case, nor any other case… its done fro the gray panel at bottom. There are three wires that connect at back of timer. make sure boiler power is turned off. make a note of where the wires go.. .disconnect, reconnect new timer.. . Bingo..

You can indeed. This timer is compatible, or the MT10RF would be also if you want it to keep it wireless. 0 of 0 found this answer helpful. Was this helpful?

21 of 23 ( 91%) reviewers would recommend this product. All Boilers and Boiler Accessories must be installed by a Qualified Gas Safe Registered professional. An easy to use analogue clock for setting heating time periods. For use with I, Si Combi and CDi combi only. Add to basket for…