Why is my Arlo pro camera not working?

Unplug your Arlo Go camera, remove the battery, reinsert the battery, and notice the camera LED behavior when the door is closed. If your camera is still offline, try moving it to an area with better mobile coverage. If that does not work, you might need to reset your Arlo Go camera and set it up again.

Why are my Arlo Pro 2 cameras not recording?

Before you reset your base station, try removing one of the cameras from the system and reconnect it again see if that helps! Try erasing/deleting some or all videos from you library as well!

How do you know when an Arlo camera is recording?

To determine the status of your Arlo camera, refer to the LED on the front face of the camera.

Why is my Arlo not saving recordings?

This could be due to old firmware on the base station/cameras. Check your firmware versions and make sure they are up to date. Log in to your Arlo account and navigate to Settings > My Devices > select desired device > Device Info > Firmware.

How do I resync my Arlo Pro 2 camera?

Press the Sync button on top of the camera for about two seconds and then release the button. Note: Cameras must be synced one at a time. A blue LED on the camera blinks rapidly to confirm sync. If the LED on the camera blinks amber, the sync is not successful.

Where is the reset button on Arlo camera?

To reset your Arlo Go camera while it is not connected to the cloud:

Press and release the sync button on the top of the camera. You hear a click.
Hold the camera about 4 to 8 inches (10 to 20 cm) in front of this QR code until you hear a chime: Your Arlo Go camera is reset to factory default settings.

Why is my Arlo camera not working anymore?

[Solution] Arlo Camera not Working 1 Check your Arlo library for the last recording for that camera. If the most recent video for that camera was recorded a… 2 Open and close the camera battery door. If the LED blinks blue once and it does not rapidly blink blue later, you must… See More….

How do I Sync my Arlo camera to my base station?

If you’re using a Arlo Wire-Free, Arlo Pro Wire-Free, Arlo Pro 2 Wire-Free, or Arlo Go camera, press the Sync button on the top of the camera. If the blue LED is blinking rapidly, your camera is syncing with the base station. Repeat these steps for each camera that you want to sync. Note: You must sync cameras one at a time.

What’s the maximum range for an Arlo camera?

If your device is connected to an Arlo SmartHub or base station, you can place your Arlo device up to 300 feet (90 meters) away from the Arlo SmartHub or base station. The maximum range is reduced by each wall, ceiling, or other major obstruction between the camera and SmartHub or base station.

Why is my Arlo Ultra Pro 3 not syncing?

Note: If the Sync button on the base station is pressed for too long, the LED blinks amber. If this happens, wait for 15 minutes and then try the sync process again. If you’re using an Arlo Ultra Pro 3, Pro 3 Floodlight, or Essential wire-free camera, you do not need to press the Sync button.

How many cameras can Arlo support?

If you don’t have an Arlo Smart subscription, Arlo supports five cameras. However, if you purchase one of the following kits, the service plan supports six cameras:

How does the Arlo wireless camera work?

How Do Arlo Cameras Work? Arlo cameras are wireless and powered by four CR123 lithium 3-volt photo batteries. Arlo cameras use infrared sensors to monitor any motion at night or in any dark areas of your home. A word of warning though, it does use up battery power compared to cameras using other forms of light for a source.