Why is my hot tub water getting low?

This can be a common issue and is likely caused by either the spa suction being open and there’s not enough water returning to the spa or it’s a faulty check valve. Check the suction side lever that is connected to the spa so see if it’s open. There’s also the Ortega check valve and some others.

How do you test a spa circulation pump?

Check that your power is on, the breaker or GFCI test button are not tripped, all valves are in the open position. Follow the circ pump plumbing, and look for any kinks in the hose. Pull out the cartridge filter to see if flow improves and the circulation pump is doing better.

Can a hot tub pump be repaired while the power is off?

Do not perform any repairs on a hot tub pump until after the power has been disconnected. This may involve a circuit breaker or a separate box mounted near the pump. Never work on water-moving devices while the electricity is running. Remove the spa circulation pump.

What’s the best way to fix a spa pump?

To install bolts, snug each one in a clockwise direction, and then start over and tighten each bolt down, in the same pattern. This helps to give you an even, consistent seal. Restore the power to the motor and turn it on. If all has gone well, the leaks will be fixed. If you still have leaks, repeat the process.

Why is my spa pump not working properly?

The inlet or outline line could become a clogged outlet. The pump may leak around the base, or it may not operate at all. Any malfunctions other than these should probably be attended to by a trained professional, but these problems may have simple solutions.

How do you mount a spa pump back on a motor?

Carefully mount the pump back on the motor. If there is a gasket between the pieces, make sure it is properly in place before installing the bolts. To install bolts, snug each one in a clockwise direction, and then start over and tighten each bolt down, in the same pattern. This helps to give you an even, consistent seal.

What should I do about my hot tub pump?

Here we discuss hot tub leaks, broken hot tub or spa jets, hot tub or spa water temperature & heater repair, hot tub or spa pump diagnosis & repair, hot tub or spa filter maintenance, cleaning & repair, noisy air pumps at hot tubs, noisy water pumps at the hot tub or spa, and other hot tub, spa or whirlpool bath diagnosis & repair topics.

What to do if your spa pump is not working?

With over 25 years of experience, we’re equipped to help with any spa issues you have or to discuss a new spa. When your spa pump is making noises… This usually happens if you recently drained the spa. Open the lock nut until you hear air hissing, then tighten up again as water begins to leak.

What causes a hot tub pump to fail?

Typical hot tub pumps fail more often because they are internally cooled, allowing moist or dusty air to contaminate the interior components of the pump. The spa pump from Arctic Spas is completely sealed and externally cooled to prevent premature failure. Looking for a spa heater, jets, or other component?