Why is my slide out not working on my car?
Why is my slide out not working on my car?
To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.
Is there an electrical problem with the slide out?
Finding an apparent electrical button, the control panel was removed and the wires for the stuck slide were placed on another slide “in/out” button. Again, there was no power to the stuck slide when the “In” was pushed. The two young mobile repair techs were now perplexed and did not have the skill to trouble-shoot the electrical issue.
Why is my passenger side slide not retracting?
My trip to Baton Rouge for LSU football this past weekend went to heck when my passenger side slide would not retract (we stayed Thursday night in Lake Charles, LA to visit my son’s family). After calling a couple of Lake Charles RV repair shops, the initial thought was the slide motor had quit working.
Are there two relays for the slideroom motor?
Missing a circuit to supply power to slideroom motor.The drawing pictures one relay to power the in and out voltage to the motor- there are 2 power relays.
To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
Where are the rods that drive the slide out?
The opening is just to the left and below the yellow wire screw caps (first photo with old motor) Square rods that drive the slide bars are attached on both sides of the motor gear box (second photo with new motor). The slide-out that was stuck open is also shown below.
Is the Lippert slide out controller a problem?
A final update for my slide-out problem. The good folks at RV Masters in Houston diagnosed the problem to be a “bad” Lippert Slide-Out Controller. The “in/out” switch and relay all work fine and were not the problem. A new controller was installed and the slide out is working great again!
Are there any problems with the slide out?
Most slide out problems are not that difficult to trace and then solve. There will be those that require the help of a professional technician to repair. The key would be to get to know your system and learn when the task is beyond your abilities to handle .
Are there any problems with the slide out on an RV?
Troubleshooting RV Slide Out Problems: One main problem with slide outs is that they may get out of alignment. The good news here is that each slide can be adjusted separately. All you have to do to fix it is take your RV to a dealer and let them make an adjustment.
Why is my slide out motor not working?
RV Slide Motor not Working. The bad news is that one of your slide out motors may have died. The good news is that the failure is due to a faulty wire or connection which caused a short and tripped a breaker. The latter may not be the case if you have 2 motors on your slide out and one is still working.
The opening is just to the left and below the yellow wire screw caps (first photo with old motor) Square rods that drive the slide bars are attached on both sides of the motor gear box (second photo with new motor). The slide-out that was stuck open is also shown below.
Why are the slide outs on my RV leaning?
Sometimes that will contribute to the leaning look or tilt the slide outs a little. This problem may be caused by the fact that your RV is not level. An out of level RV will throw your slide outs out of true level and make them harder to operate.
Sometimes that will contribute to the leaning look or tilt the slide outs a little. This problem may be caused by the fact that your RV is not level. An out of level RV will throw your slide outs out of true level and make them harder to operate.
A final update for my slide-out problem. The good folks at RV Masters in Houston diagnosed the problem to be a “bad” Lippert Slide-Out Controller. The “in/out” switch and relay all work fine and were not the problem. A new controller was installed and the slide out is working great again!
What happens if you push the slide out button?
If you push your slide-out button and nothing happens, double check to make sure that the path of the slide out is unobstructed. A stray item wedged in your slide out can be an easy fix, so go check before tearing your motorhome apart looking for the slide motor.
My trip to Baton Rouge for LSU football this past weekend went to heck when my passenger side slide would not retract (we stayed Thursday night in Lake Charles, LA to visit my son’s family). After calling a couple of Lake Charles RV repair shops, the initial thought was the slide motor had quit working.
If you push your slide-out button and nothing happens, double check to make sure that the path of the slide out is unobstructed. A stray item wedged in your slide out can be an easy fix, so go check before tearing your motorhome apart looking for the slide motor.
What to do if your power sliding door is not working?
If your power sliding doors are not functioning correctly, either by using the door switch or the keyless remote switch, try resetting them to see if the problem is corrected. If resetting the doors does not fix the problem, there may be other problems with the power sliding door mechanism. See your Honda dealer for assistance.
Why is the sliding door on my Sienna XLE not working?
It would only work when I pulled the handle. Here is a breakdown of the symptoms I was having with my 2004 Toyota Sienna XLE: All of this is pointing to the motor inside the door that essentially “pulls the handle” for you when you remotely open the door.
Why does my rear slide out not work?
Rear slideout won’t engage. 2007 crossroads cruiser ct32. Rear slideout won’t engage. There is 12v at the motor, when switch engages it drops to zero. Running power to the switch direct from battery permits the slideout to work …
What to do when slide outs don’t move?
Make sure the house batteries are charged completely, or if at all possible, plug your RV into shore power. This will indicate whether the problem may be the batteries or not. If you push the button for the slide outs and can hear the motor running but the slides don’t move, check the motor’s shear pins.
Why does my coachmen slide out not work?
KevinS121 Some college 952 satisfied customers 2007 crossroads cruiser ct32. Rear slideout won’t engage. 2007 crossroads cruiser ct32. Rear slideout won’t engage. There is 12v at the motor, when switch engages it drops to zero.
Finding an apparent electrical button, the control panel was removed and the wires for the stuck slide were placed on another slide “in/out” button. Again, there was no power to the stuck slide when the “In” was pushed. The two young mobile repair techs were now perplexed and did not have the skill to trouble-shoot the electrical issue.
Why are my slide outs not going in or out?
If you hear a weird noise when you try to extend the slides, it could be the pump trying to work. If you just can’t seem to make those slide outs go in or out, it is possible on most RVs to manually extend or retract the slides.
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
What happens when you push the slide out button on an RV?
If your RV or motorhome doesn’t have the juice, your slide outs aren’t going to budge! If you push your slide-out button and nothing happens, double check to make sure that the path of the slide out is unobstructed.
How big is a Minnie Winnie double slideout?
The 31H double slideout floorplan features bunk beds, U-Shaped Dinette and your choice of sofa/bed or theater seating. And finally, the Minnie Winnie 31K floorplan is a single slideout floorplan that measures 32’9″ in length and sleeps up to 7 people.
How big is a Winnebago Minnie Winnie bedroom?
And finally, the Minnie Winnie 31K floorplan is a single slideout floorplan that measures 32’9″ in length and sleeps up to 7 people. The 31K features a U-Shaped Dinette, large bedroom and your choice of a sofa/bed, TrueComfort+ Sofa or Theater Seating.
How big is a Minnie Winnie the Pooh?
The Minnie Winnie 22M is 24’5″ in length with a rear bed in the slideout. The 22M includes a U-Shaped Dinette and sleeps up to 5 people.
Where does the power come from to power the slide in?
One to power the slide in and one to power the slide out. input to the common point of the repay pictured is pictured; but that power should come from a larger fused supply with the key switch only controlling the relay coils of the in and out relays / with a limit switch to stop the slideout travel and to stop the slide at a in or park point.
It apparently has 2 motors which are synchronized to work each end of the slide when I press the extend or retract button. One of the two motors stopped working. My Thor motorhome manual does not show a fuse for the motors in the fuse panel. (1) Is there a fuse for these motors & if so, where will I find them?
What to do when your slide out doesn’t slide in?
If the battery has plenty of juice, the next place to look is in your fuses and circuit breaker. Is there any noise coming from the motor that runs the slide out when you hit the switch?
Why is my slide out wall switch not working?
Hence, no power to the wall … read more My slide out switch don’t have power, the slide out 40amp brake does the wires. Coming from their the wires does it goes on the walls but can’t find it … read more Dining Room slide is not working. Absolutely nothing happens Dining Room slide is not working.
Why does my slide out brake not have power?
My slide out switch don’t have power, the slide out 40amp brake does the wires. Coming from their the wires does it goes on the walls but can’t find it … read more
What to do if your slideout does not move?
If your slideout does not move at all when you operate the slideout control switch, and you do not hear the motor or the pump running, then the first thing to check is the switch itself. If you have multiple slideouts, try one of the other switches to see if it is operating.
What kind of power do you need for a slide out?
The slideout pathway should be clear from tables, people, trees, electrical posts, etc. You have enough power supply. RV’s slideout system is operated by a 12 volt DC electric motor and you need to make sure that you supply it with enough power through a converter or a fully charged 12-volt battery. Your vehicle is leveled.