Why is my water softener light flashing?

A light may be blinking to alert you that the system needs salt. A water softener needs salt in order to remove hardness from its softening resin. So if your water softener detects that it doesn’t have the salt that it needs, it will alarm you with beeping and often, with blinking lights.

What happens when water softener is low on salt?

What happens if water softener runs out of salt? Hardened calcium and magnesium minerals build up in your pipes and cause less efficiency in your water heating system. The showerhead and sink can be covered with a white crust that causes the water flow to spray in all directions.

Should you reset water softener after adding salt?

The HARDNESS and RECHARGE TIME never require resetting unless a change is desired. However, regenerations may occur at the wrong time of day until you reset the clock to the correct time of day. NOTE: If the water softener was regenerating when power was lost, it will now finish the cycle.

How do you reset the low salt light on a Morton water softener?

Press the ON/OFF-HOLD button and hold in for 3 seconds. RECHARGE NOW and FILL begin to flash (or clean backwash begins, if set) as the softener enters the fill cycle of regeneration. When FILL is on steady, remove the brine well cover and, using a flashlight, observe fill water entering the tank.

What does recharge now mean on water softener?

Recharge Now: The water softener will immediately begin to recharge. In approximately 2 hours you will have a new supply of soft water. During recharge the softener goes into an automatic bypass. Although you will not have soft water during this time, hard water will be available.

Should there be water in my water softener salt tank?

The brine tank is the part of your water softener that holds the salt. Your water level should always be slightly lower than your salt level in your water softener brine tank. That is why it is important to always make sure that your water is lower than the salt.

When to add water to a salt water softener?

While a water softener only uses the saltwater (commonly known as brine) in the tank for a short amount of time, usually about 90 minutes. Most types of softeners add water to the salt tank at the very end of their cleaning process.

Why does my water softener keep beeping and flashing?

A water softener needs salt in order to remove hardness from its softening resin. So if your water softener detects that it doesn’t have the salt that it needs, it will alarm you with beeping and often, with blinking lights.

How can I get my water softener to stop mushing?

Follow the steps below to rid your water softener of salt bridges or mushing: Break up the salt bridge with a broom handle. Remove salt mushing by draining and cleaning the tank and refilling it with fresh salt. The resin in your water softener does the hard work of capturing the minerals to make hard water into soft water through ion exchange.

What are the most common water softener problems?

Common Water Softener Problems. 1 1. Water Softener Problems Water In Salt Tank. Perhaps the primary concern water softener users are facing is a salt tank full of water. This usually 2 2. Water Softener Problems Salt Bridges. 3 3. Water Softener Makes Water Brown. 4 4. Water Softener Doesn’t Use Salt. 5 5. Brine Tank Water Too Low.

Why does my salt water tank Flash on and off?

RECHARGE NOW and FILL begin to flash (or clean backwash begins, if set) as the softener enters the fill cycle of regeneration. When FILL is on steady, remove the brine well cover and, using a flashlight, observe fill water entering the tank.