Why is the backlight not working on my keyboard?
Why is the backlight not working on my keyboard?
Most keyboards have backlight illumination and glowing letters but, sometimes, this neat feature will refuse to work. If that’s the case with your laptop, the problem is usually not with the keyboard.
What to do if your camper Jack is not working?
DANGER: Keep camper levelwhen raising or lowering (within 4-6 inches). Due to weight differences at each corner, jacks will not raise and lower at same speed. Stop frequently and check level of camper KEEP REMOTE UNIT AND ALL CONNECTIONS DRY Do not leave out in rain or plugged in when not using. ALWAYS unplug and stow remote when not in use.
How to troubleshoot Ground Control 3.0 troubleshooting guide?
GROUND CONTROL 3.0 TROUBLESHOOTING GUIDE Auto Level Sequence 1. Front landing gear retract, lowering the front of the unit below level, stopping, then lifting the front end to level the unit front to back and left to right. (Fig. 7A). 2. Rear leveling jacks are grounded (Fig. 7B). 3. A side to side leveling sequence occurs.
Why is the touch screen on my LCI not working?
Small red lights are on. None of the buttons work. Received new touch pad but no difference. The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue.
Why does the alarm go off when the jacks are up?
The level does not have to drop much to cause the alarm, on mine only a cup or two. Near the top of the fluid reservoir, there is a fluid level switch.The fluid level must touch that switch before the jacks down light will go off.My system uses dexron auto trans fluid. Your owners manual will specify what type of fluid your system uses.
Why is my Lippert ground control not working?
The back light comes on, but no words, It seems like everything else works, I can press the auto level button and it works. I can press the retract button and retract the landing jacks, I just cant see anything on the display. This is on my touchpad connected to the RV. Not a remote. Anything I can do? The good news is your system is working.
DANGER: Keep camper levelwhen raising or lowering (within 4-6 inches). Due to weight differences at each corner, jacks will not raise and lower at same speed. Stop frequently and check level of camper KEEP REMOTE UNIT AND ALL CONNECTIONS DRY Do not leave out in rain or plugged in when not using. ALWAYS unplug and stow remote when not in use.
GROUND CONTROL 3.0 TROUBLESHOOTING GUIDE Auto Level Sequence 1. Front landing gear retract, lowering the front of the unit below level, stopping, then lifting the front end to level the unit front to back and left to right. (Fig. 7A). 2. Rear leveling jacks are grounded (Fig. 7B). 3. A side to side leveling sequence occurs.