Why is water coming out of my condensate pipe?
Why is water coming out of my condensate pipe?
The condensate trap and pipe come straight out of the heat exchanger, which means that if it cracks or pinholes, it will cause system or mains water to drain into the condensate pipe. What may lead to the condensate pipe leaking is if the hot water causes the pipe joints to fail somehow.
Where should boiler condensate pipe go?
Where an installer is fitting a new or replacement boiler, the condensate discharge pipe should be connected to an internal “gravity discharge point” such as an internal soil stack (preferred method), internal kitchen or bathroom waste pipe such as sink, basin, bath or shower waste.
Do condensing boilers need a drain?
All modern condensing boilers require a condensate pipe to run to a suitable drain. It can be taken to the outside, run internally, or even pumped through a 10mm plastic tube rising vertically, then to a drain.
How do you know if your boiler is condensing?
If you can see the steam coming from the flue through an external wall (or roof), and if you also have a white plastic pipe leading to a drain, this will certainly be from a condensing boiler.
Why do you need a condensate pipe in a boiler?
The condensate pipe is used to drain all the excess water produced from the condensing process in your boiler. Since the water, aka the condensate, is mildly acidic (that’s because it is a by-product of the condensed waste gasses), it needs to be drained through a PVC or ABS pipe.
Which is the only plastic pipe connected to the boiler?
As metal pipework cannot be used, it is often easily identifiable as the only plastic pipe connected to the boiler. Before it is discharged into the sewer via the condensate pipe, waste water – or condensate as it’s known – is collected in the condensate trap. Condensate pipes are generally considered to be a component of the boiler’s flue.
What kind of pipe do I need for a condensate discharge pipe?
installing boiler condensate discharge pipes Only fit an external boiler condensate drain connection if an internal gravity or pumped connection is impractical to install. The pipe work from the boiler should be of a minimum 19mm ID or as per manufacturer’s instructions and the condensate discharge pipe shall be run in a
How does the condensate trap work in a boiler?
In many boilers, the condensate trap contains a small siphon. The trap collects condensate until it fills up to a level where the siphon is activated. The trap then empties itself automatically. Condensate flows through the pipe in bursts of a few hundred millilitres at a time. This may be heard trickling through the pipe.
What kind of pipe is needed to drain condensate from boiler?
The condensate pipe is used to drain all the excess water produced from the condensing process in your boiler. Since the water, aka the condensate, is mildly acidic (that’s because it is a by-product of the condensed waste gasses), it needs to be drained through a PVC or ABS pipe. Any metal pipe used would corrode.
How does condensate get expelled from a boiler?
Once enough heat is produced from this vapour, it’s condensed back into water form. After this water has been collected, it gets expelled out the condensate pipe. A typical hour-long operation of your boiler may produce around 2 or 3 litres of the condensate water waste.
As metal pipework cannot be used, it is often easily identifiable as the only plastic pipe connected to the boiler. Before it is discharged into the sewer via the condensate pipe, waste water – or condensate as it’s known – is collected in the condensate trap. Condensate pipes are generally considered to be a component of the boiler’s flue.
Can a condensate pump be installed in a boiler?
Manufacturers Instructions must be referred to when installing boiler condensate discharge pipes. If there is no gravity route available for a condensate pipe, you could get a condensate pump installed. The condensate either has to go into a drain or into its own purpose-built soakaway.