How does sleep mode work on a Balboa?
How does sleep mode work on a Balboa?
Toggle between READY and REST by pressing temp. Press light or wait for 10 seconds to go back to the Main Screen. Sleep Mode (sl) = heats to within 10 degrees (less) than preset temperature and only during the filtration cycle. Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours).
How to exit rest mode on a Balboa?
On screen it will just state rest mode or whilst running filteration it will state “run” “pump” “for” “temp”. TO EXIT REST MODE:- Press Temp, then press light repeatedly until ‘MODE’ appears in the LCD. Toggle between READY and REST by pressing temp. Press light or wait for 10 seconds to go back to the Main Screen.
What does SL mean on a Balboa hot tub?
Sleep Mode (sl) = heats to within 10 degrees (less) than preset temperature and only during the filtration cycle. Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours). Preset cycle set from factory is F1, so if in ec or sl mode your water will not reach desired temperature.
How to change the range of the Balboa?
To change the range press the temp/warm button followed by the light button, then press temp/warm button again. To exit, press the light button or wait for 10 seconds to go back to the Main Screen. To check, next to range there is an arrow – if pointing down its in low range, if pointing up its in high range.
When to use sleep mode on a Balboa?
The filter will be going still, but the heater heats less often, and the jets only go every few hours rather then every hour or so in standard mode. It’s so you can keep the spa going 24/7 but save money when not using it.
Sleep Mode (sl) = heats to within 10 degrees (less) than preset temperature and only during the filtration cycle. Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours). Preset cycle set from factory is F1, so if in ec or sl mode your water will not reach desired temperature.
How to change the temp on the Balboa?
High Range can be set between 26.5°C to 40°C. Low Range can be set between 10°C to 36°C. To change the range press the temp/warm button followed by the light button, then press temp/warm button again. To exit, press the light button or wait for 10 seconds to go back to the Main Screen.
How do you turn on sleep mode on a spa?
Press “Mode” to enter mode programming, press “Cool” to cycle through to desired mode (LCD flashes until confirmed), then press “Mode” to confirm selection. Sleep mode heats the spa to within 11°C (20°F) of the set temperature only during filter cycles. “ ” will appear on the display until mode is changed.